Replacement 7-Way Connector Needed for 2007 Nissan Frontier

Published 11/08/2017

Products Featured in This Question

Replacement Wiring Harness for Tow Ready Nissan Vehicle Wiring Harness

(108)

$38.01

Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Nissan and Infiniti

(1065)

$16.63

Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional

(6648)

$165.67

Curt Relay Kit for Nissan Armada or Titan Aftermarket Tow Package

(158)

$29.87

Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End

(732)

$16.16

Pollak Black Plastic, 7-Pole, RV Blade-Style Trailer Socket - Vehicle End

(341)

$13.33

LCD Digital Circuit Tester

(26)

$26.67

Question:

Thanks that helped me out big time now I need a trailer brake controller

asked by: Micael

Helpful Expert Reply:

If you need to change out the complete wiring harness on your 2007 Nissan Frontier then you will need the Replacement Wiring Harness # 118267.

If you have the US carr connector still intact then you can use the Pollak # PK11893, but if you just have bare wires you would want the Pollak # PK12-707E instead.

I have attached a picture with the typical wiring setup for a vehicle side 7-Way. You will want to use a Circuit Tester # PTW2992 to verify the different functions of your wiring if you don't already know what each wire is for.

expert reply by: Jon G

click to enlarge

Micael

11/8/2017

Thanks that helped me out big time now I need a trailer brake controller

Jon G.

11/8/2017

As long as you have the relays # C57000 already installed on your 2007 Frontier with the tow package, and you have a fully functioning 7-Way, you will simply need a brake controller that has a plug-in adapter. You can use the previously mentioned Circuit Tester # PTW2992 to test and make sure all of the functions are operational. I highly recommend the Tekonsha Prodigy P3 # 90195 as it is very easy to install and use. It allows you to easily adjust your braking power as well as save different settings for easier setup. The LCD screen makes using this controller very easy since you do not have to remember what different codes mean like you do with other options. To install this brake controller you will just need the Adapter # 3050-P and plug it in under the driver side dash. I have attached a video of this installation being done on a 2010 Frontier that you can use as a reference.