Hubs with 5 on 5 Bolt Pattern that Will Fit a Timbren Axle-Less Suspension System
Updated 11/03/2017 | Published 11/02/2017
Products Featured in This Question
Question:
I was looking at the timbren axle =less suspension, and was wanting to know if there is a hub with the lugs at 5x5 to match my jeep 16inch wheels. is so what is the product info Thanks
asked by: Scott
Expert Reply:
There are Timbren axle-less suspension systems that do not come with hubs so that you could add your own such as # AKIHUB-550-35-EZ-K. But the hubs with 5 on 5 bolt patterns that would also fit a Timbren system only accept up to 15 inch wheels. The other issue is that vehicle wheels are not meant to be used on trailers and often have an offset (mounting surface of wheel not in the dead center of the wheel) whereas most trailers take wheels with a zero offset.
With that said the hub listed above will fit on Timbren axle-less system:
# ASR2KHDS03
# ASR3500S05
# ASR3500S06
# ASR2000S02
# ASR2KHDS04
# ASR1THDS01
# ASR1THDS03
# ASR2KHDS02
# ASR1200S03
# ASR3500S04
# ASR2KHDS01
# ASR1200S04
# ASR2KHDS05
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Heavy Duty - Long Spindle w/ 4" Lift - 4 Bolt - 2K
- Trailer Axles
- Rubber Spring Suspension
- Standard Grade
- No Hubs
- 2000 lbs
- Spindles Only
- Universal Fit
- Lift - 4 Inch
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: safety chains
- Shop: Timbren Axle-Less Trailer Suspension - Heavy Duty - Long Spindle w/ No Drop - 4 Bolt - 2K
- Shop: Timbren Axle-Less Trailer Suspension - Heavy Duty - No Drop - 4 Bolt Flange - 2,000 lbs
- Q&A: Could The Timbren Axle-Less Suspension Be Used For Tow-Behind-Motorcycle Coffin Trailer?
- Video: Complete Breakdown of the Timbren Axle-Less Trailer Suspension w/ Idler Hubs
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Galvanized
- Shop: Timbren Axle-Less Trailer Suspension w/ Idler Hubs - Standard Duty - No Drop - 5 on 4-1/2 - 2K
- Shop: Lock N Roll Articulating Channel Tongue Trailer Coupler - 2" Channel - Trailer Side
- Video: Let’s Check Out the Single Axle Trailer Fender for Enclosed Trailers
- Video: Front Runner Flat Upright Water Tank: The Breakdown
- Video: Single Axle Trailer Fender w/ Backing Plate Review
- Video: A Closer Look at the Lock N Roll Articulating Trailer Coupler for 2" Receivers
- Video: Timbren Axle-Less Trailer Suspension System Test Course
- Q&A: Availability Of Replacement Rubber Aeon Springs For Timbren Axle-Less Suspension
- Shop: Timken Bearing Kit, L44643 Inner/Outer Bearings, L44610 Inner/Outer Races, 204507 Seal
- Shop: Easy Grease Trailer Idler Hub Assembly for 2K Axles - 5 on 4-1/2 - Galvanized
- Video: Review of etrailer Trailer Hubs and Drums - Galvanized Idler Hub - AKIHUB-545-35-G-EZ-K
- Q&A: Recommendation for Converting Fleetwood Neon Pop-Up to Axle-Less Suspension System with Jeep Tires
- Q&A: Recommended Timbren Axle-Less System with 5 on 5 Bolt Pattern Hubs for Overland Trailer
- Q&A: Availability of 2,000 Pound Timbren Axle-Less System with 6 Hub Face Dimension
- Q&A: Replacement Foot Plate for a Lippert Jack 359278
- Q&A: Is There a 3,500 Lb Idler Hub with Hub Bore Less Than 64MM
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Article: Double-Eye Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
on Trailer Axles
