Optronics LED Trailer Tail Lights with 3-Prong Plug

Question

Question:

St66rpg trailer light has moulded 3 plug...is there an led version with same plug in...nneed both driver and passenger

asked by: Terry P

0

Expert Reply:

For an LED-version of the Optronics light # ST66RPG you can use their parts # STL37RB and # STL36RB. These do not include the 3-prong plug but we offer these, right-angle part # A47PB and straight plug part # A45PB.

expert reply by: Adam R

0

Answer 1

Hello George, thanks for reaching out. From what I've found online, the LED Tail Light for Trailers #STL17RB is the recommended drivers side replacement for the S2T216AP2. This is a 8-1/16" long x 2-7/8" tall x 2-13/16" deep tail…

view full answer...

Answer 2

I believe you are looking for the GloLight LED Trailer Tail Light #OPT54WR. This has the same 3 pin connector as in your image. The overall dimensions of this light are 7-1/2" wide by 3-5/16" tall and 1-1/8" deep. If you have a…

view full answer...

Answer 3

Would you be able to send me some pictures of what your current lights look like and the triangular plugs that you mentioned so I can help you get something that works best?

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

We've had similar questions in the past that used the number you referenced and we were able to determine that the taillight kit replacement was the part #TLL160RK.

view full answer...

Answer 10

Hey Rick. Unfortunately that's correct the Wesbar Tail Light 271594 has been discontinued. Our best option for replacing it is the LED Trailer Tail Light item #STL36RB for the passenger side and item #STL37RB for the driver side. The Wesbar light…

view full answer...

Optronics LED Trailer Tail Lights with 3-Prong Plug

Products Featured in This Question

Continue Researching