Where Does Drilling Take Place to Install Curt Hitch C11001
Updated 10/17/2017 | Published 10/15/2017
Question:
Which part of the rear i need to drill?
asked by: Malvic H
0
Expert Reply:
I attached a picture that I took from the install instructions for the Curt hitch part # C11001 that you referenced that covers the section on drilling the frame.
Press hitch against the bottom of the bumper beam, using the hitch as a template mark hole locations with a center punch. Lower hitch and drill hole locations with 17/32" drill bit.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Q&A: How to Attach Curt Class I Trailer Hitch # C11001 to Bumper Frame on 2014 Mercedes-Benz E-Class
- Q&A: Trailer Hitch for a 2014 Mercedes E350 Sedan with Sport Package
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch Recommendation for a 2011 Mercedes E350 Sedan
- Q&A: Hitch Recommendation for a 2011 Mercedes Benz E350 Sedan
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Q&A: Brake Controller for a 2012 Honda Pilot
- Article: Trailer Wiring Diagrams
- Q&A: Hitch Fit for a 2024 Chevy Equinox EV
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited