Replacement Coupler Recommendation for Fulton 33305

Question

Question:

Want to replace my coupler parts, is there a replacement kit or would I have to replace the whole 2inch A frame hitch? Thanks,

asked by: Brad N

0

Expert Reply:

It doesn't look like we have an exact replacement coupler latch kit available for your trailer coupler. Your best option would be to replace your coupler with something like the # CA5100B which is also a A-frame coupler designed for a 2 inch ball but it has a 10k capacity.

expert reply by: Jameson C

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Hi Ron! To get the 12v power port on your 7-Way working, you will want 12 gauge wire and a 40 amp circuit breaker (I have both listed below). This will get you needed power and protection for your Curt Echo Wireless Brake Controller #C51180. 12 Gauge…

view full answer...

Answer 3

Based on my research the Shelby 5101 is an A-frame coupler with a 2" ball and 5,000 lb capacity. We have exactly that with the A-Frame Coupler #CA5100B, which has a trigger latch and has a black paint finish. The same coupler is available with a…

view full answer...

Answer 4

Hey Roger, I was able to pull up the dimensions of the battery you have now and found that the Bright Way replacement battery part #3801250 is exact same dimensions and is also a 5 amp hour battery so it would work great for you.

view full answer...

Answer 5

Hey Patrick, thanks for reaching out. Yes, the Replacement Front Jack Leg #LC362485 should work for your 2021 Open Range 314RLS with the Lippert Ground Control 3.0 system. Since your weld stop “bump outs” measure 17-1/2" apart, that matches the…

view full answer...

Answer 6

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

view full answer...

Answer 7

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 8

Hey Timothy! The brake controller port on the Sprinter is located under the driver seat. The connector picture below will fit into the port and allow you to install a brake controller like the Redarc Tow-Pro Elite #RED52CR. I also linked an…

view full answer...

Replacement Coupler Recommendation for Fulton 33305

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching