Where is Brake Controller Install Port on 2016 Ram 1500

Question

Question:

I ordered part number 3024p harness and cant find the plug to plug it in I found a little one that resembles the one pictured but is too small to plug in to 3024 p. The vehicle is a 2016 Dodge ram 1500 Lonestar edition. I have the 7 and 4 pin plugs on rear bumper so I am assuming I have the plug for trailer brakes

asked by: Richard S

0

Expert Reply:

Your truck does have the connector needed to plug in the part # 3024-P that you mentioned. When we installed this harness in a 2016 Ram 1500 just like yours we found the connector dangling under the dash to the right of the steering wheel like in the picture I attached. You can also fast forward to the 3:25 portion of the install video I attached to see this as well.

The brake controller installed in this video is the P3 part # 90195 which is our best option.

expert reply by: Jameson C

0

click to enlarge

Answer 1

For your 2019 Nissan Titan I recommend the Curt hitch part #C13304 as it has the highest weight capacities and has the shortest install listed as well. I attached an install video and picture for you to check out as well.

view full answer...

Answer 2

Even though your 2017 Nissan Titan doesn't have the tow package it should still have the standard round connector to install trailer wiring behind the rear bumper. Part #N40975 includes the 7-way and 4-way connector that plugs right into your…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 9

Hello Kevin, Thanks for writing in. The main difference between the Power Watchdog Surge Protectors #HU67FR and #HU42VR comes down to the monitoring capability, housing design, and surge protection rating. The #HU67FR is the newer Generation 2 model.…

view full answer...

Where is Brake Controller Install Port on 2016 Ram 1500

Featured Help Information

Miscellaneous Media

Continue Researching