Replacement Fan Motor for Fan-Tastic Vents 4000-Series Roof Vent

Question

Question:

will FVK8017-00 work in my fan-tastic vent 4000R?

asked by: Steve

1

Helpful Expert Reply:

You can use part # FVK8017-00 to replace the bow-tie bracket, motor, and fan blade for your Fan-Tastic Vent 4000-series roof vent.

expert reply by: Adam R

1

Answer 1

It sounds like you might have a Create-A-Breeze B8100 model fan, which is a Fantastic Vent series fan. The correct replacement for the fan and motor on 8000 series units is the Replacement Fan Motor Assembly Kit for Fan-Tastic Vent Roof Vent Fans…

view full answer...

Answer 2

According to our FAQ on slipper springs, linked for referenced, the torque specs are as follows: Torque Ratings 1/2 inch Bolts: 45 ft/lbs - 70 ft/lbs 9/16 inch Bolts: 65 ft/lbs - 95 ft/lbs 5/8 inch Bolts: 100 ft/lbs - 120 ft/lbs The Replacement…

view full answer...

Answer 3

The torque of U-bolts for 3,500 lb axles such as the 95" long Dexter Trailer Axle Beam #7359765 or 89" long Dexter Trailer Axle Beam #T3584F-EZ-8974 depends on the diameter of the U-bolts. I have cut out a part of our help article on…

view full answer...

Answer 4

Most likely you hit a strange bump and it happened to flip your shackle the wrong way. If you use a floor jack to jack up the rear axle it will go back to the right orientation. If it happens repeatedly that would indicate your leaf springs are too…

view full answer...

Answer 5

Furrion unfortunately does not sell their connectors separately for some unknown reason and I haven't seen any Y-adapter connectors like you'd see with any other system. When it comes to connecting them together the only way to is in series…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Replacement Fan Motor for Fan-Tastic Vents 4000-Series Roof Vent

Product Page this Question was Asked From

Continue Researching