Replacement AC Shroud for Coleman Mach RV Air Conditioner

Question

Question:

I want to replace the shroud on my 2002 Arctic Fox 22H travel trailer. The air conditioner model # is 8333A876 and I believe the part number is 8333-4161. Can you tell me which shroud will work? The approximate measurements of the original shroud are 28W by 42L by 13 1/2H. Thank you for your help.

asked by: Jan L

0

Expert Reply:

Part 8333-4161 refers to a shroud for a series of Airxcel AC units. We do not offer this exact part number but our MaxxAir TuffMaxx Replacement Shroud # MA00-325001 is almost an exact match to your dimensions and is a confirmed fit for Mach 1, Mach 3 and Mach 15 models. Please refer to the linked photo for dimensions.

Keep in mind that these shrouds generally have a good bit of flex to them and so a cover whose dimensions may vary slightly from the original can often still work fine.

expert reply by: Adam R

0

click to enlarge

Answer 1

I looked up this Greystone Range Hood G22BRHT-EL-VD and it appears to be a 22" wide vent hood for a ducted system. While we do not have a direct replacement available, we do carry the Ventline Pinnacle Ducted RV Range Hood #VE78SR which is a…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replacement AC Shroud for Coleman Mach RV Air Conditioner

Continue Researching