Kayak Carrier for a Hobie Pro Angler 14 on a Yakima Rack and Roll

Question

Question:

I have a Yakima RacknRoll trailer, but I need to know what Yakima kayak accessory would work with a Hobie Pro Angler 14 and its large frame and weight. The bars on the trailer are round. Thanks

asked by: Mike

0

Expert Reply:

I recommend the Malone MegaWing Kayak Carrier # MPG207 to carry your Hobie Pro Angler 14. The Malone fits onto the Yakima round bars and has a maximum weight capacity of 150 pounds. From my research the kayak weighs between 110 to 140 pounds so this is a great option for you.

expert reply by: Charles S

0

Answer 1

I did some research on your 2021 Hobie Outback, and the hull measures 34 inches wide. For a width of 34 inches, the Malone MegaWing Fishing Kayak Carrier with Tie-Downs #MPG207 will be able to carry it on a crossbar system. If you wish for me to…

view full answer...

Answer 2

Yes, your two Kaku Zulu kayaks will fit the Yakima Rack and Roll Trailer #Y08107. You can strap them directly to the crossbars or use a carrier like the Malone MegaWing Fishing Kayak Roof Rack w/ Tie-Downs #MPG207.

view full answer...

Answer 3

The Bunk Kit for Malone MegaSport Trailer - 1 Kayak #MPG561 is not a fit for your Yakima Rack and Roll Trailer - 78" #Y08107. It may be able to be adapted to fit, but It would take some work and wouldn't be supported by the manufacturer. My…

view full answer...

Answer 4

Both the Yakima Rack and Roll Trailer #Y08107 and Malone MicroSportXT Trailer #MPG460XT will work for you to carry your two Hobie kayaks, but I recommend the MicroSport XT because it is the better value of the two trailers. The biggest difference…

view full answer...

Answer 5

The CE Smith Boat Trailer #CE48810 will work well with your Hobie Pro Angler kayak. This trailer is very versatile. The bunks can be moved in and out and the angles adjusted to fit all manner of watercraft. I have linked a video review for you.

view full answer...

Answer 6

Your best bet is to add the Tongue Extension Kit for Yakima Rack and Roll Trailer #Y08109 to your Rack N' Roll trailer which will increase the capacity from one 17' long or two 16'-long boats to one 22'-long boat or two 21'-long…

view full answer...

Answer 7

You have a good eye because your Hobie Pro Angler 14 kayak would easily be transported with the Rack and Roll trailer, which is the following part number: - Yakima Rack and Roll Trailer - 78" #Y08107 The #Y08107 is able to haul up to 250 lbs,…

view full answer...

Answer 8

Yes the Malone EcoLight Sport Single Kayak Trailer #MAL73FR would work great for transporting your Hobie Pro Angler 14. It has over twice the weight capacity you'd need, has carpeted bunks you could angle to match the hull shape of your boat, and…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Kayak Carrier for a Hobie Pro Angler 14 on a Yakima Rack and Roll

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching