Suspension Enhancement Recommendation for 2011 GMC Sierra with 2 inch Drop

Question

Question:

I am looking for a rear suspension enhancement spring set for my 2011 Sierra 1500 Denali crew cab short bed 6.2L/AWD. I am looking for a jounce style spring. I need something that will work with 2inch shackles, so not factory ride height. Do you carry anything I could use for this?

asked by: Andrew

0

Expert Reply:

I have a solution, but we don't have any jounce style suspension enhancement kits for your truck with a 2 inch drop.

Only option we have is the part # AL59209 which is an air kit that is designed for vehicles with drops like yours.

expert reply by: Jameson C

0

Answer 1

Hey Brandon, I would strongly recommend sticking with the Tekonsha RF brake controller part #TK94FR. We know this works really well and it sounds like it worked well for you too. The Curt Echo is not reliable enough for me to really ever recommend it…

view full answer...

Answer 2

I don't have the minimum installed height of the Air Lift SlamAir Air Helper Springs for Lowered Trucks part #AL59103 as you put but I can confirm that the kit is designed for a vehicle with a 2-4" drop. If you need more, you can use the Air…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 9

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 10

Hey Bob. There's two possible locations for the brake controller port on your 2026 Ford F-150. The most likely one is on your dash behind the coin holder above the 4WD knob. It'll be connected to the back of the coin tray which is only…

view full answer...

Suspension Enhancement Recommendation for 2011 GMC Sierra with 2 inch Drop

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching