Recommended Trailer Hitch Receiver, Wiring Harness, and Other Parts to Tow with a 2014 Kia Sorento

Updated 05/23/2017 | Published 05/21/2017

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(640)

$209.94

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(168)

$76.40

Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"

(112)

$187.81

B&W Tow & Stow 2-Ball Mount - 2" Hitch - 5" Drop, 5-1/2" Rise - 7.5K - Black

(4621)

$269.00

Blue Ox Trailer Hitch Receiver Lock for 2" Hitches

(194)

$34.95

Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-1/4" Span

(895)

$13.90

Question:

I have a 2014 Kia Sorento LX that I want to add a class 3 2inch hitch and wiring kit to. I want to be certain which one to get. The website narrowed it down to two different ones. Can you confirm which hitches will fit this car?

asked by: Brian P

Expert Reply:

The two Class III trailer hitch receivers that fit your 2014 Kia Sorento LX are the Curt # C13152 and the Draw-Tite # 75772. Both have a similar design and look once installed. The Curt has a higher weight capacity but the Draw-Tite is still rated well above what your Sorento can tow so that shouldn't be a deciding factor for you.

If I had to choose one I'd go with the Curt just because of the amount of positive reviews we've received. The Draw-Tite's reviews are just as positive but there aren't near as many of them.

The wiring harness I recommend is the Tekonsha # 118583. This provides a 4-way trailer connector on the rear of your Sorento. To install the harness you'll need to remove the Kia's tail lights and plug it in in-line with the tail lights' wiring. Then you'll need to run a hot lead wire to the positive side of the battery and insert the fuse. All of the wiring and the fuse is included.

You'll also need a ball mount and hitch ball. I've attached link of our selection of ball mounts for a 2 inch hitch receiver as well as an article to help you determine the correct rise or drop you may need. Once you choose a ball mount you can then choose a hitch ball to fit it.

One way to make choosing a ball mount easier is to go with an adjustable ball mount like the B&W Tow & Stow # BWTS10038B. It features the ability to be flipped under the hitch when not using it and will provide up to 5-1/2 inches of rise or 5 inches of drop.

For a pin and clip to fit you can use # PC3 or if you'd like to have a locking pin you can use # BX8858.

I've also included links to some articles on towing that you might find helpful.