Replacement Locking Knob for Yakima SpareRide Bike Carrier

Question

Question:

Hey guys, I was looking to purchase a used SpareRide The original, not the 2 from a buddy who had replaced the bolt within the locking knob to accommodate his giant tires. Im looking for the measurements of the stock bolt and cant seem to find anyone who carries it. Im under the impression they use a JIS head type here? Thanks for any insight!

asked by: Mike

0

Expert Reply:

The Replacement Locking Knob # 8890239, which is a compatible replacement part for both the Yakima SpareTime and SpareRide Bike Racks, has a 65mm bolt length and a M12 thread pitch.

If you are wanting to replace the locking knob assembly, this product also includes the washer and SKS control key.

expert reply by: Chris R

0

Answer 1

I can not confirm or deny if we have any replacement knobs for your Bauer bicycle rack without any information on the rack, however due to the age I am going to assume probably not. We do have the Replacement Bolt & Locking Knob for Surco 51953…

view full answer...

Answer 2

The Locking Knob #P1030 is specific to the Swagman Upright Bike Rack #S64720. The only other locking knob we carry is the #P1040 which fits the Swagman Original and XP Series bicycle carriers manufactured after 2009. This knob will thread onto a…

view full answer...

Answer 3

Yes the thread size of the knob part #TH79JV is M8 so it is perfectly compatible with the T-bolt part #853-0782 that you referenced.

view full answer...

Answer 4

I called my contact at Surco and they told me the Replacement Bolt & Locking Knob, part #SPN-104 is a 3/8 inch diameter bolt and it has 16 threads per inch. This is a replacement knob for a Surco Bike Rack, 51953.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 12

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Replacement Locking Knob for Yakima SpareRide Bike Carrier

Continue Researching