Will TorkLift PowerArmor Locking Battery Box # TLA7712R Fit a 2011 Lance 2185

Question

Question:

Will this torklift power armor battery box fit on my 2011 Lance 2185?

asked by: Paul

1

Helpful Expert Reply:

TorkLift PowerArmor Locking Battery Box # TLA7712R is a universal fit type of item so it can fit just about anything. I looked at some pictures of the 2011 Lance 2185 and it appears that there is some space between the front of the body and the propane tanks. If that space is greater than 9-3/4 inches then the battery box will fit.

expert reply by: Michael H

1

Answer 1

Hello Chris, Great question, in fact it was such a great question that I needed to reach out to my contact at SnapPad because I could not find that information anywhere. He stated that the SnapJack SJ RV Scissor Jack Pads - Qty 4 #SN32FR will work…

view full answer...

Answer 2

To prevent your truck battery from draining from an auxiliary trailer battery like you plan to install when the vehicle is off you'd need to install an isolation solenoid on the 12 volt accessory circuit like with the part #PK5231201. This will…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Will TorkLift PowerArmor Locking Battery Box # TLA7712R Fit a 2011 Lance 2185

Product Page this Question was Asked From

Continue Researching