What is the Width of the E-Z Lube Grease Caps # RG04-010

Question

Question:

how do you measure or what do you measure for the rubber plug that fits on the greese cup. Example for part # RG04-010 thanks

asked by: Don C

0

Expert Reply:

The 1.18 inches that is in the product description is taken from the back side of the E-Z Lube Grease Caps # RG04-010 that lodges inside the E-Z Lube Dust Cap. See attached photo.

expert reply by: Jon G

0

click to enlarge

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The 1.18" width on the Grease Cap Plug for E-Z Lube Grease Caps #RG04-010 is the only size that is offered.

view full answer...

Answer 3

Hey Tom, all I really need to know to pick out the correct bearings would be the axle capacity of your 2023 Grand Design 390RK. Since we happen to already know you have 8k axles the correct bearing kit would be the #DX38ER which comes with new…

view full answer...

Answer 4

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 5

Your Dexter D44 Axle number 635096 uses the Trailer Hub and Drum Assembly #8-407-5UC3-EZ that comes preloaded with the Races #LM67010 and #L68111. It does include the Bearings #L68149 and #LM67048, Grease Seal #58846, Grease Cap #21-42-1 and lug…

view full answer...

Answer 6

Begin by removing the master cylinder cap and fill the reservoir to three quarters full with DOT-3 brake fluid. DO NOT allow brake fluid to contact painted surfaces since it will damage the finish. Wipe up any spills immediately and wash the area…

view full answer...

Answer 7

Based on the numbers and RPM you listed on your Dutchman 2007 trailer the correct slide out motor setup you need is the part #LC125802 that is a Tuson High Speed 18:1 9,000 RPM slide out motor.

view full answer...

Answer 8

You definitely can send in photos of your Dexter EZ Lube 85-1 cover, but according to my research the Grease Caps #RG04-040 are what you're looking for. These fit a standard 1.98" hub bore and come with the rubber plug so you can easily…

view full answer...

What is the Width of the E-Z Lube Grease Caps # RG04-010

Product Page this Question was Asked From

Continue Researching