Which Pins of the Switch Part # PK34360 Are for Each Circuit
Updated 11/16/2021 | Published 02/11/2017
Question:
Hello I have just purchase the below item: Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 3-Blade - Red Pilot Light Code: PK34360 Can you please tell me which of the blade terminals are Power, Accessories and Ground?
asked by: Heston Z
Helpful Expert Reply:
On the back of the # PK34360 the terminal in the corner with the pin next to it is the power pin, the one right next to it with the silver rivet is the ground. The light terminal is the one opposite of those two in the other corner.
I attached a picture that shows the terminals pointed out.
Product Page this Question was Asked From
Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 3-Blade - Red Pilot Light
- Accessories and Parts
- Wiring
- Switches
- Rocker Switches
- 20 Amp
- Pollak
more information >
Continue Researching
- Shop: Side Window Vents
- Video: In-Depth Review of the 10 Gauge Primary Wire
- Shop: Brake Controller
- Search Results: 2 cameras rv camera system
- Search Results: 12v wire
- Search Results: rv camera system
- Search Results: toggle switches
- Search Results: 12 volt light switches
- Search Results: curt triflex
- Search Results: demco reed switch
- Shop: RV Backup Camera System - Rear mount - 7" Screen
- Shop: 10 Gauge Wire - Red Primary - Per Foot
- Shop: RV Camera
- Shop: Vehicle Tow Bar Brake System
- Q&A: Are Each of the Switches On the Buyers Products Pre-Wired Switch Box Fuse Protected
- Shop: Roadmaster Universal Braking Monitor for Flat Tow Brake Systems
- Shop: Demco Wireless Coachlink Braking Monitor for Flat Tow Brake Systems
- Shop: Curt TriFlex NEXT Trailer Brake Controller w/ Custom Harness - 1 to 4 Axles - Proportional
- Shop: Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 3-Blade - Red Pilot Light
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Video: A Closer Look at the Buyers Products Pre-Wired Switch Box w/ Relay and Circuit Breaker
- Video: Curt Brake Controller C51458 Review
- Video: Checking Out the Buyers Products Pre-Wired Switch Box w/ Relay and Circuit Breaker
- Q&A: Error Codes on a Portable Power Watchdog Surge Protector
- Q&A: Wiring Diagram for Lippert Components Kwikee Step Rocker Switch # LC371010
- Q&A: Parts Needed to Install a 7-Way and Trailer Brake Controller on a 2023 Kia Sorento X-Line
- Q&A: Can A Weight Distribution System Be Used With A 2022 Kia Telluride
- Q&A: Wiring Installation of Kwikee Step Control Unit
- Q&A: How To Wire a Set of Kwikee Steps Using Only a Rocker Switch
- Article: Trailer Wiring Diagrams
Angel M.
11/12/2021
The fuse keeps blowing. Not sure why have 3 mat connected with 10 gauge wire running to them. Not sure if I am connecting the switch right. Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 3-Blade. Using this switch.