Can SuperSprings Be Used in Conjunction with Air Bags

Question

Question:

Would it be better or worse to use super spring with airbags?

asked by: Mike

0

Expert Reply:

As long as the installation of the airbags on the truck and the SuperSprings Custom Suspension Stabilizer and Sway Control Kit # SSA16MXKT do not interfere with one another combining them will be an improvement.

expert reply by: Charles S

0

Answer 1

I do have a solution, but since Lance has their own plug design there are no adapters that will work, including the #47595. The best option is to replace the lance plug with a standard 7-way blade connector like the #PK12706. This will eliminate the…

view full answer...

Answer 2

You certainly can use a SuperSprings Custom Suspension Stabilizer and Sway Control Kit on your 1999 Ford F-250 4WD with an air bag system installed. Out selection includes part #SSA16 with a 1,650 lb capacity, part #SSA22 with a 2,200 lb capacity,…

view full answer...

Answer 3

I checked with Roadmaster for you, and I verified that the thickness is 1-3/8 inches for the anti-sway bar: - Roadmaster Rear Anti-Sway Bar #RM-1139-153 This is good because the thicker the anti-sway bar, the more roll stiffness there is, which means…

view full answer...

Answer 4

Yes, the Roadmaster Rear Anti-Sway Bar, #RM-1139-153 is designed to replace the existing part and designed to work with most aftermarket parts. This is a much stronger sway bar than factory, made with stronger steel than factory and increased to…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Can SuperSprings Be Used in Conjunction with Air Bags

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching