How Does Camco Changeover Bracket # CAM59005 Mount

Question

Question:

does this dual auto regulator come with a vertical mounting bracket?

asked by: Robby

0

Expert Reply:

You would want to mount the Changeover part # CAM59005 vertically as that is how they are normally installed. Basically the two fittings that are gold in color will end up between the bottles and the other fitting on the portion of the product with the blue cap will face down.

This does not come with the bracket nor do we carry them.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 2

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 3

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 4

The difference between the prices of the JR Products Automatic Changeover LP Gas Regulators and Camco Automatic Changeover 2-Stage Propane Regulators are in the BTU per hour, which as you correctly noted, is important information. The JR Products…

view full answer...

Answer 5

Hi Anny, 1. The Uniguard Elbow Kit part #65UGA2 is not compatible with 1 1/4" pipes, it's a dedicated 1 1/2" fitting. If you need to fit the UniGuard to a 1 1/4" pipe, they make a reducing slip joint washer that can connect the 1…

view full answer...

Answer 6

The Winntec 6020 is an automatic changeover regulator, and the best option we have to replace it is with one from Camco, which is the following part number: - Camco Automatic Changeover 2-Stage Propane Regulator for Dual Propane Tanks #CAM59005 This…

view full answer...

Answer 7

Hey James, we can only get the Voyager Camera System part #ASA52FR as a kit that includes the rear camera that you said you didn't need so this would be only way we could help you. I would still go with this kit and either leave the rear camera…

view full answer...

Answer 8

To add a regulator to your 100-lbs propane tank that will allow you to use a Mr.Heater 85000 btu system I recommend using something like the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L - 160,000 Btu/Hr #CAM59333 which is designed to provide…

view full answer...

Answer 9

The Automatic Changeover RV LP Gas Regulator part #37207-30395 will be a great replacement for the Fairview GR-9984. The fittings are all the same so it should be an easy bolt-on swap. They are both auto-changeover regulators with an 11" W.C…

view full answer...

Answer 10

Hey Ray, thanks for reaching out. If you are set on placing the propane tank inside the toolbox, it can be done safely as long as the box is properly vented at the bottom. Propane is heavier than air, so if there is ever a small leak it will settle…

view full answer...

How Does Camco Changeover Bracket # CAM59005 Mount

Product Page this Question was Asked From

Continue Researching