How to Tell if a Trailer Spindle is Damaged or Needs to be Replaced
Published 08/16/2016
Question:
We just pulled our old popup Coleman into an rv park and noticed a squeak, the barrings are shot on driver side. How do I know if the axle is bad also? Repaor cost? Thank you for any advice!!
asked by: Stuck M
Expert Reply:
If you remove the hub and wipe away the grease on the spindle you can check to see if it is damaged. Look for an scarring, gouges, discoloration, or scoring on the spindle. If the spindle is damaged then the bearings won't ride properly and can fail again or it can cause other problems such as uneven or excessive tire wear and ride quality problems.
If the spindle is damaged then you can't really repair it and the whole axle should be replaced. I doubt that this is the case based on your description of the problem though. I have linked a video that might also help.
Product Page this Question was Asked From
Square #84 Spindle for 3,500-lb Trailer Axles - 1-1/2" Wide
- Trailer Spindles
- Standard Spindle
- Without Flange
- L68149
- 1-1/2 Inch Diameter
- Square
- For 3500 lb Axle
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: kodiak 225 brake pads
- Search Results: brake rotors
- Search Results: lugnut
- Search Results: deemaxx brake pads
- Search Results: stove vent
- Search Results: electric fireplace
- Search Results: gate valve
- Shop: DeeMaxx Ceramic Brake Pads for TruRyde Disc Brakes - 3,500 lbs to 6,000 lbs
- Shop: Lippert Ceramic Disc Brake Pads - 7,000 lbs to 8,000 lbs - Qty 4
- Shop: Lippert Spindle Nut Kit w/ Round Washer - For 2,200-lb to 4,400-lb Axles
- Shop: Dicor Non-Sag Cap Sealant - Clear
- Shop: Dicor Non-Sag Cap Sealant - White
- Shop: Dicor Self-Leveling Lap Sealant - 10.3oz - Dove
- Video: DeeMaxx Hub and Rotor Assemblies Brand Spotlight
- Shop: Kodiak Ceramic Brake Pads - 3,500 lbs to 6,000 lbs
- Video: All About the Kodiak Ceramic Brake Pads
- Video: Review of DeeMaxx Trailer Hubs and Drums - Galvanized Oil Hub 9K 10K General Duty Axle - DE36NR
- Q&A: How To Find Correct Replacement Grease Seal for a Trailer Axle
- Video: CE Smith Trailer Hub Assembly w/ Carrying Case for 2,700-lb Axles Spec Review
- Video: 3500lb Trailer Idler Hubs Direct Comparison
- Video: Complete Breakdown of the Timbren Axle-Less Trailer Suspension w/ Idler Hubs
- Video: Review of the AquaFresh Exterior RV Water Filter
- Q&A: Identifying the Bearings and Seals on a Lippert Trailer Axle
- Q&A: Tips for How to Identify a Trailer Axle
- Q&A: Replacement Hub and Spindle for Dexter 69-46 Axle
- Q&A: Best Replacement for a Dexter 69 - 46 A2 Axle
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: Are Dexter Bearing Kits as Good as Timbren Bearing Kits for Trailer Axle
- Q&A: Does a Spindle with Scarring and Complete Bearing Failure Need to be Replaced
- Article: Most Popular Wheel Bearings
on Trailer Spindles
