Installation of Firestone Ride-Rite Air Helper Spring Kit F2550 in 2002 Ford F-250

Question

Question:

Hello, just received the Firestone f2550 kit and noticed my factory bump stops will be right about in the middle of the airbag section. Any help will be gladly appreciated. Thank you

asked by: Scott W

0

Expert Reply:

If you refer to the linked video at the 1:25 mark you can see the process for removing the factory bump stop. This video shows Firestone Ride-Rite Air Helper Spring Kit # F2550 installed in a 2002 Ford F-250 like yours. You'll need to keep the bump stop's metal collar for re-installation.

expert reply by: Adam R

0

Answer 1

Both the Firestone Air Spring Kits part #F2071 and #F2550 have been confirmed to fit your 2001 Ford F250 Super Duty 4x4. The main reason we recommend the #F2550 over the #F2071 is because Firestone says this kit is compatible with gooseneck and fifth…

view full answer...

Answer 2

We do indeed offer replacement air bags for the Firestone Ride-Rite #F2550 air helper spring kit. The replacement springs are sold individually as part #F6401. These springs have the same 5000 lb leveling capacity as the original springs that were…

view full answer...

Answer 3

I spoke with Firestone about this and the brackets of the #F2597 are a little different design but their capacity is still the same. Their recommendation was to go with the new kit because of the better design. If you decide to replace the brackets…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Installation of Firestone Ride-Rite Air Helper Spring Kit F2550 in 2002 Ford F-250

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching