Replacement Shank for Blue Ox Alpha Tow Bar BX7380
Updated 09/12/2026 | Published 07/01/2016 >
Question:
Have a blue ox alpha that is a year old and has about 5000 miles of pulling.The swivel part works just fine .The problem I have is it is hard to get the storage pin into the holder,the pin is getting very sloppy in the hole. Either the pin wearing out or the hole is getting egg shaped.Is there a fix for this?
asked by: Tom W
Expert Reply:
On the Blue Ox Alpha Tow Bar # BX7380 the vertical bracket on the shank that accepts the pin when storing the tow bar in the vertical position comes from the factory with an oval slot. My contact at Blue Ox confirmed this is the only bracket ever supplied on that tow bar and it is shown in the linked photo. It is designed to allow the tow bar to lean either towards the driver- or passenger-side when stored.
You can certainly add a tie-down strap or bungee cord to help secure the tow bar when it is in the stored position.
You can also submit a photo or two of the bracket if you wish. This tow bar carries a 3-year warranty. If the problem is the hole in which the pin is installed, then do please send photos. Excessive wear in that mounting hole is unusual and this should for safety reasons be addressed with Blue Ox.
Product Page this Question was Asked From
Blue Ox Alpha Non-Binding Tow Bar - RV Mount - 2" Hitch - 8,500 lbs
- Tow Bar
- Hitch Mount
- Telescoping - Non-Binding
- Steel
- 8500 lbs
- Fits Blue Ox Base Plates
- Stores on RV
- Cables Included
- Blue Ox
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Base Plate for Tow Bar
- Video: Review of Demco Tow Bar Braking Systems - Reinstall Kit - SM99226
- Shop: Vehicle Tow Bar Wiring
- Shop: Roadmaster Direct-Connect Base Plate Kit - Removable Arms
- Shop: Replacement Hardware Kit for Roadmaster Falcon All-Terrain and BlackHawk 2 All-Terrain Tow Bars
- Shop: Coach Air Kit for Demco Air Force One Flat Tow Brake System
- Shop: etrailer SD Non-Binding Tow Bar for Roadmaster Direct-Connect Base Plates - RV Mount - 6,000 lbs
- Shop: Towed Vehicle Reinstall Kit for Demco Air Force One Flat Tow Brake System
- Shop: Trailer Hitch
- Search Results: baseplate
- Search Results: towed vehicle lights
- Q&A: Flat Towing A 2019 Buick Envision
- Video: Installation Guide for the Demco Air Force One Flat Tow Brake System Reinstall Kit - 2024 GMC Canyon
- Video: Demco SBS Air Force One Coach Air Kit Installation - 2003 Coachmen Cross Country Motorhome
- Video: Replacement 7-Wire to 6-Wire Cord for Roadmaster Nighthawk Tow Bar Review
- Shop: Replacement 7-Way to 6-Way Coiled-to-Straight Cord for Roadmaster Nighthawk Tow Bar - 8' Long
- Video: Demco SBS Air Force One Coach Air Kit Installation - 2019 Tiffin Allegro Red Motorhome
- Shop: Vehicle Tow Bar Brake System
- Shop: Roadmaster Diode 7-Wire to 4-Wire Flexo-Coil Wiring Kit
- Q&A: Flat Tow 2019 Buick Envision Set Up
- Q&A: Recommended Flat Towing Set Up for a 2019 Buick Envision
- Q&A: Repair Parts for a Roadmaster Blackhawk 2 All Terrain Tow Bar
- Q&A: Bushing Replacement and Repair Kit for Roadmaster Sterling Tow Bar 011019
- Video: Review of Roadmaster Complete Sterling Tow Bar Repair Kit - RM-910003-30
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Video: An In-Depth Look at the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Search Results: trailer wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)



Dan P.
9/12/2026
No matter what I do when I try to stow the arms using the pin it backs out and up when I move the arms to either side. I have tried pushing into the Rv with the arms together, separating them shoulder width and pushing one toward the coach and one down. There is no rotating of the bracket that holds the arms. I have hit that with dry lube and nothing. Could this have been an error on the installers part? Ideas?