Air Bag Kit Recommendation for Front Axle of 2000 Workhorse P30 Chassis
Updated 04/27/2016 | Published 04/24/2016
Question:
Is this tbe correct application to replace the airbags inside the springs on the front of my motorhome? I also need rear sway bar bushings for my 11/2inch sway bar. Do you have them?
asked by: Craig S
Expert Reply:
The Air Lift Kit part # AL81560 that you referenced is the correct air bag kit for the front springs of your 2000 Workhorse P30 chassis that your Itasca Sunrise is built on. You would need to remove what is there now and install these in place of them.
I wish we had the bushing you need, but at this time we do not have stock sway bar bushings for RVs like yours.
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Front
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Front Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Suspension Enhancement
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Front
- Q&A: Front Air Bags for 2004 Workhorse P32 Chassis
- Q&A: Air Bags for the Front Coil Springs for an RV Built on a 2002 Workhorse P32 Chassis
- Q&A: Can the Air Lift WirelessAIR Compressor System Operate 4 Bags Independently?
- Q&A: What Kind of Chassis is My 2009 Damon Avanti Built On & What Suspension Enhancement do You Carry?
- Q&A: Air Bag Kit for a 2019 Chevy Silverado 3500 Cab and Chassis
- Q&A: Front Air Bag Suspension Kit that Fits 2003 Workhorse RV Chassis
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: What Should Tire Pressure be for a Load Range G 110 psi Tire
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Trailer Wiring Diagrams
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Performance Chips and Modules
- Article: Brake Controller Installation: Starting from Scratch