Nut Size Used to Raise and Lower the Stromberg Carlson Scissor Trailer Jack # JSC-24-IND
Updated 08/06/2010 | Published 08/04/2010
Products Featured in This Question
Question:
What is the size of the hex nut for raising the jack?
asked by: Jared
0
Expert Reply:
The nut for raising and lowering the Leveling Scissor Jack - 24 inch Lift - 5,000 lbs, item # JSC-24-IND, from Stromberg Carlson is 3/4 inch. A 19 mm wrench or socket can also be used.
We carry a jack handle, item # JCH-1, with the proper size socket for use with these jacks.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Leveling Scissor Jack - 24" Lift - 5,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Scissor Jacks
- Steel
- 4001 - 5000 lbs
- Manual Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Search Results: brake away cable
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Leveling Scissor Jack - 24" Lift - 5,000 lbs
- Q&A: Does Mounting Hardware Come With Leveling Scissor Jack
- Q&A: Replacement Scissor Jack for 2014 R-Pod Camper
- Q&A: What is the Overall Length of Leveling Scissor Jack # JSC-24-IND when Fully Retracted
- Q&A: Mounting Dimensions for Stromberg-Carlson Leveling Scissor Jack # JSC-24-IND
- Q&A: Dimensions of Mounting Holes for Stromberg Carlson Scissor Jack # JSC-24-IND
- Q&A: What is the Width Between The Mounting Plates On The Leveling Scissor Jack # JSC-24-IND?
- Q&A: Do Mounting Plates of Stromberg Carlson or Ultra-Fab Scissor Jacks Remain Level When Jack is Raised