RV Sewer Hose Seal Recommendation to Provide Odor Proof Connection

Question

Question:

Im a camp host at a campground with full sewer and when the hose on Motor home is in sewer tank odors escape. Does this product seal that?

asked by: Lorna H

0

Expert Reply:

For what you are looking for the part # CAM39313 would be perfect.

This 4" x 3" sponge ring works with the gray-water seal or directly on an RV sewer hose for an odor proof connection to a dump station.

expert reply by: Jameson C

0

Answer 1

The Waste Master RV Sewer Hose w/ Camlock Fittings, Nozzle, and Endcap - 20' Long #LC359724 has the cylinder camlock as you mentioned. This cylinder diameter is 3-1/2 inches inside and 4 inches on the exterior due to the fitting wall thickness of…

view full answer...

Answer 2

The Waste Master RV Sewer Hose #LC359724 uses a camlock fitting for connection to the motorhome's waste pipe. I went to our warehouse and measured the part shown in the linked photo. From both ends to the stop in the center measures 1-7/8-inches,…

view full answer...

Answer 3

We do have what you are looking for as the part #T1009. This will replace the flange side of your waste valve that you sent in a picture of and give you bayonet fittings you can attach to your sewer lines. It's hard to say but it looks like yours…

view full answer...

Answer 4

A sewer hose that is too long is an annoyance. One that is too short makes for a mess! It is possible to trim the hose down, remove the parts inside of the end that you cut, then use some solvent, #A05-0303, to "glue" the now shorter hose…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 9

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 10

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 11

If your 2021 Mercedes-Benz Sprinter 3500 is a van then yes, the Roadmaster Rear Anti-Sway Bar #RM43VR is the only compatible option. If your 2021 Mercedes-Benz Sprinter 3500 is a Class C motorhome then you also have the option of the Roadmaster Rear…

view full answer...

RV Sewer Hose Seal Recommendation to Provide Odor Proof Connection

Product Page this Question was Asked From

Continue Researching