Replacement Modular Base Recommendations For Both Sides Of TracRac TracOne Ladder Rack

Question

Question:

Im looking for both sides Replacement Modular Base for TracRac TracOne Ladder Rack. I could only find one side on your site.

asked by: Ken B

0

Expert Reply:

The replacement module for the TracRac TracOne Ladder Rack is part # 8528382001 for the driver side front or passenger side rear.

For the passenger side front or driver side rear you would need part # 8528383001.

expert reply by: Jeffrey L

0

Answer 1

The replacement pieces in aluminum for the Thule Rack are Right Front/Left Rear - Qty 1 item #8528383001 and Left Front/Right Rear - Qty 1 item #TAPT-27001. These replace the Modular Base for Thule TracRac Fixed Mount Ladder Racks.

view full answer...

Answer 2

We have both the Fixed Bases for the Front Left #TAPT-27001 and Front Right #8528383001 on your Thule TracRac. We also have the Slider Bases for the Front Left #TA01-42003 and Front Right #TA01-42004 if you have the SR rails.

view full answer...

Answer 3

Yes, the Replacement Modular Base for TracRac Fixed Mount Ladder Rack part #TAPT-27001 is correct for you. This is for the left front and right rear upright. If you need the one for the right front or left rear upright then you will need the…

view full answer...

Answer 4

The matching modular base to go along with part #TAPT-27001 is part #8528383001. This replaces either the passenger side front or driver's side rear base of a TracRac TracOne or T-Rac Pro2. This comes in a quantity of one so you'll need to…

view full answer...

Answer 5

For replacement bolts for what you have you'd want the Replacement Hardware for TracRac G2 and T-Rac G2 Fixed Mount Ladder Racks #TA7521653001. This comes with the bolts you need plus some additional ones.

view full answer...

Answer 6

The corresponding or opposite part from the Replacement Modular Base for TracRac Fixed Mount Ladder Rack - Left Front/Right Rear #TAPT-27001 is the Replacement Modular Base for Thule TracRac Fixed Mount Ladder Rack - Right Front/Left Rear - Qty 1…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Replacement Modular Base Recommendations For Both Sides Of TracRac TracOne Ladder Rack

Products Featured in This Question

Continue Researching