Troubleshooting Roadmaster Invisibrake that Shows Zero Pressure
Published 11/09/2015
Question:
What causes the invisible brake to loose the air pressure I after setting it. Can stop the motor home for 10 minutes and the pressure will drop.
asked by: Kenneth T
Expert Reply:
Are you sure the pressure is being lost and not actually maxed out? If the air pressure of the InvisiBrake part # RM-8700 is set to the maximum the gauge will actually spin completely around the gauge and show zero.
To confirm that the compressor is operating properly, pull out on the brake pressure adjustment knob and rotate it counterclockwise. The needle will move as you lower the pressure. Adjust to desired pressure setting.
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Flat Tow Brake System
- Brake Systems
- Pre-Set System
- One-Time Setup
- Vehicle Battery
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Indicator Lights
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Vehicle Tow Bar Brake System
- Shop: Vehicle Tow Bar Wiring
- Q&A: Does Roadmaster Invisibrake Fit 2024 Jeep Rubicon
- Q&A: Will Curt RVibrake Shadow 2 Fit 2026 Ford Maverick Hybrid
- Q&A: Flat Tow Setup for 2012 Jeep Grand Cherokee Overland
- Q&A: Recommended Flat Towing Set Up for a 2026 Ford Maverick Hybrid
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Best Flat Tow Setup for 2026 Ford Maverick Hybrid
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Must-Have Flat Towing Components
- Q&A: Parts Needed to Flat Tow 2021 Jeep Wrangler 4xe
- Q&A: Recommended Parts for Flat Towing a 2025 Ford Maverick
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Flat Towing Package for 2015-2018 Ford F-150
- Article: Trailer Wiring Diagrams