Can the Pack'Em Trimmer Rack # PK-6 be Used on a Trailer with Tubular Rails
Updated 11/09/2015 | Published 11/06/2015
Question:
I want a trimmer rack but the top rail on my trailer is pipe not angle will this rack work on this?
asked by: Michael M
0
Expert Reply:
You could still use the Pack'Em Trimmer Rack # PK-6 on your trailer with the rounded frame. The rack could potentially want to pivot.
To prevent that you could put a brace between the two up rights. So you would run a bolt through the frame, through an upright, and through one end of a flat steel bar. Then do the same on the other side. The brace between the 2 uprights would help prevent them from twisting.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Pack'Em Trimmer Rack for Utility Trailers
- Trimmer Racks
- Utility Trailer
- 3 Trimmers
- Pre-Drilled Holes
- Locks Included
- PackEm
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availaiblity of White Half Moon Trailer Vent
- Article: How to Measure a Trailer Axle
- Q&A: Installation of Emergency Break Away Cable Repair Kit for Dexter Axle A-60 Brake Actuators
- Q&A: Can Pack'Em Trailer Racks be Welded to Trailer Instead of Bolting On
- Q&A: What is the Recommended Distance Center to Center for the PackEm Trimmer Rack # PK-6
- Q&A: Troubleshooting Happijac Remote Control And Logic Board Compatibility
- Q&A: Recommended Trailer Hitch for 2025 Hyundai Palisade
- Q&A: Comparing Uni-Servo and Free Backing Hydraulic Drum Trailer Brakes
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Install E-Track in 3 Easy Steps
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices