Will a 28 Inch Spare Tire Fit Inside of DeeZee Specialty Series Trailer Tongue Toolbox DZ91717
Updated 10/26/2015 | Published 10/25/2015
Question:
Ive got an almost 28 inch tall spare tire that I would like to mount inside the 7.24 cu. ft. Triangle Trailer Box. I can fabricate a mount to hold tire at an angle, but wonder if you have done this and/or have any suggestions. Thanks for your assistance.
asked by: Danny D
Expert Reply:
Even at an angle I do not think a 28 inch tall tire will fit in toolbox # DZ91717. The box measures 22-3/4 inches tall, 19 inches front to back, 34 inches long at the back and 20-3/4 inches long at the front. Basically I don't think you could get enough of an angle to fit the tire in.
To lock the spare to the trailer you could use a spare tire carrier such as # FSTC1000301 with a cable lock # FCLK150100.
Product Page this Question was Asked From
DeeZee Specialty Series Trailer Tongue Tool Box - A-Frame - Aluminum - 7.24 Cu Ft - Silver
- Trailer Tool Box
- A-Frame Tool Box
- 19 - 22 Inch Tall
- Aluminum
- 31 - 40 Inch Long
- Silver
- DeeZee
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Side Wall Vent Recommendation for an Enclosed Trailer for Maximum Air Flow
- Q&A: RV door latch for enclosed cargo trailer
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Search Results: trailer side vents
- Search Results: stabilizer jacks trailer jack
- Search Results: vent
- Search Results: hitch cargo carrier
- Search Results: trailer tool box
- Search Results: door lock for enclosed trailers
- Video: The Low-Down on the Bauer Products Camper Door Lock
- Video: Replacement Round Interior Trailer Vent for 3" Diameter Hole: The Breakdown
- Video: Comprehensive Review: Mushroom Vent
- Video: Complete Breakdown of the Bauer Products Camper Door Lock
- Video: Comprehensive Review: Valterra Deadbolt Lock for RVs
- Video: A Closer Look at the etrailer A-Frame Trailer Tool Box
- Video: What to Know About the Bauer Products Door Lock for Horse and Utility Trailers
- Shop: Stabilizer Jack - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 1
- Shop: Valterra Deadbolt Lock for RVs or Mobile Homes - Double Cylinder - Stainless Steel - 5/8" Throw
- Shop: "Junior" Locking Stainless Steel Flush Door Latch with Inside Release
- Shop: B&B Endura Range Exhaust Vent for RV - 5/8" Flange - Black
- Shop: B&B RV Heat Vent w/ Rotating Grille - Damper for 4" Duct - 4-1/8" Diameter - Black
- Shop: 2-Piece Exterior Wall Vent for Enclosed Trailers - Polypropylene - 3" Diameter Hole - Black
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Suspension Enhancement
on Trailer Tongue Box
