Can Mor/Ryde LRE Suspension Hangers Be Replaced by Dexter EZ-Flex

Published 10/22/2015

Products Featured in This Question

Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 5-3/4" Long - 9/16" Center Hole

(406)

$25.81

Front/Center/Rear Hanger for Double-Eye Springs - 3-1/4" Tall - 9/16" Bolt Hole

(313)

$12.42

Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 8,000 lbs

(612)

$434.83

Dexter E-Z Flex Equalizer Kit - Double-Eye Springs - Tandem Axle - 6,000 lbs

(44)

$282.31

Question:

I have a 2010 31ft Montana fifth wheel RV, with the LRE mor-ryde rubber suspension. This system has failed, The rubber has disintegrated and now the wheel alignment is askew and has torn the outside od the tires off. My question-can I replace this system with the e-z flex heavy duty suspension?

asked by: Jerry T

Helpful Expert Reply:

To replace your current Mor Ryde LRE system and go with an EZ-Flex system is possible, but you will need to replace the center hangers as well as the equalizers to do this.

To pick out the correct equalizer will require you to measure the distance between the bolt holes from left to right on your current setup so that you can get the correct EZ Flex.

If the distance is between 7-1/4 and 8-1/4 inches the part # K71-653-00 would be the correct equalizer.

If the distance is between 5-1/4 and 6-1/4 inches you would need part # K71-654-00.

For a center hanger you will need to measure from the bottom of the trailer frame to where the center of the bolt hole is on your current equalizer. With that info you can check out the link I attached to all of the hangers we offer. The part # 28-5 is a very popular option that is 3-1/4 inches from bolt hole center to top of hanger.