How to Determine Tire Age and at What Age Should a Trailer Tire Get Replaced
Published 10/02/2015 >
Question:
I have a 2007 Aliner Scout. It came with 5.30 x 12s and I have upgraded to ST 145/12 radials with alloy wheels. I have been told that trailer tires should be replaced based on YEARS not miles. Specifically, considering the typical use a camper gets, replacing tires about every 4 years, even if there is legal tread, is a best practice. Does this make sense to you? I know folks that replace based on treadwear and run tires as long as 8-10 years. I have seen many questions answered but they do not seem to have addressed this: what is prudent or best practice for replacing trailer tires in your view? thanks
asked by: Chris C
Expert Reply:
The common recommendation is that trailer tires should be replaced at 6-7 years of age regardless of if the tread of the tire is still good. This means 6-7 years after the manufactured date and not just when the tire was purchased.
Here's how to tell a tire's age. The DOT number code will be stamped on one side of the tire, near the bead area. This tire identification number will start with the letters DOT, then the next two numbers or letters are the plant code where the tire was manufactured. The last four numbers represent the week and year the tire was built. For example, the numbers 0410 means the fourth week of 2010.
Product Page this Question was Asked From
Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire - Load Range E
- Trailer Tires and Wheels
- Tire Only
- Radial Tire
- Load Range E
- 145/80-12
- 12 Inch
- M - 81 mph
- Kenda
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: 14 inch trailer rims
- Search Results: rv toilets
- Shop: Americana Baby Moon Trailer Wheel Center Cap - Chrome-Plated Steel - Qty 1
- Search Results: 14 rims
- Search Results: baby moon hubcaps
- Search Results: hitch
- Search Results: bearing 2585 trailer bearings races seals caps
- Search Results: jacks
- Shop: Steel Spoke Trailer Wheel - 15" x 6" Rim - 6 on 5-1/2 - Galvanized Finish
- Shop: Kenda 4.80-12 Bias Trailer Tire with 12" White Wheel - 4 on 4 - Load Range C
- Shop: Trailer Axle w/ Electric Brakes - Easy Grease - 6 on 5-1/2 Bolt Pattern - 89" Long - 6,000 lbs
- Video: All You Need to Know About the Wheel Retaining Ring
- Shop: Phoenix USA Baby Moon Hubcap - 10-1/2" Diameter - Stainless Steel - Qty 1
- Q&A: Comparable Wheel for a Vintage Accuride Trailer Wheel
- Shop: Dexter Oil Hub Plug for 8,000-lb to 15,000-lb Hubs
- Shop: Leaf Spring Center Tie Bolt with Nut, 3/8" x 3"
- Video: Review of etrailer Replacement Return Spring etrailer Ram Square Direct Weld Jack - TJD-12000-RSP
- Q&A: Replacement Anchor Yoke for 12K Dexter Axle Disc Brake Kit
- Video: Deka Butt Connector Feature Review
- Q&A: Instructions for Disassembling a 12,000 lb Bulldog Jack
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Article: How to Tell the Weight Rating of a Trailer Axle
- Video: What to Know About the Powerbuilt Deluxe Bearing Packer
- Article: Big Truck Big RV
- Shop: Trailer Wiring
- Article: Trailer Wiring Diagrams
- Shop: Floor Mats
- Shop: Performance Chip Tuners
- Q&A: Replacement 12 x 2 Inch Electric Brakes for AxleTek Trailer Axle B12E-02 12-GG
- Q&A: Axletek-12-GG Replacement Brake Assembly and Hub Recommendation


