Recommended Replacement Spring Bar for Draw-Tite Dual Cam Weight Distribution System
Updated 07/06/2015 | Published 07/03/2015
Question:
I need a replacement round spring bar for my draw-tite weight distribution with dual cam sway control system.I cant seem to find the correct one.Part # RP58114 does not work.The head, or the part of the bar that fits into the hitch is shaped differently.Thanks for any advice.
asked by: Kevin C
Helpful Expert Reply:
It sounds like you may have an older Draw-Tite weight distribution (WD) system. According to my technical contact at Draw-Tite if your spring bar has a spring and clip at the head end then you'll instead use Pro Series spring bar # PS58441, which is a set of two.
If you like you can send me a photo of your existing spring bar and head unit (and provide a part number if available) and I can check again with my technical contact to verify the correct spring bar.
Product Page this Question was Asked From
Replacement Round Spring Bar for Reese Weight Distribution System - 800 lbs TW
- Accessories and Parts
- Weight Distribution Hitch
- Spring Bars
- 750 lbs TW
- Round Bar
- Reese
more information >
Continue Researching
- Q&A: Replacement Head and Spring Bar Recommendation for Older Reese Strait Line System
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Replacement Spring Bar for Reese Dual Cam II System to Increase Tongue Weight Range 600-1,200 lb
- Q&A: Replacement Weight Distribution Spring Bars for 1000 Tongue Weight
- Q&A: Old Reese V-5 Weight Distribution System Compatibility
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Correct Replacement 1,200 lb Spring Bars for the Blue Ox 2-Point WDS
- Q&A: Pro Series Snap Up Handle Associated with part # 113913
- Q&A: Replacement Spring Bars for a Pro Series RB2 Weight Distribution System
- Article: Determining Trailer Tongue Weight
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size