Where Does the Front of the Lippert Components JT's Strong Arm Jack Stabilizer # LC191024 Attach to
Updated 05/12/2015 | Published 05/11/2015
Question:
So Im looking at the cargo space behind my 5th wheel assembly to attach my front stabilizer mounting bracket to the frame however there is no front crossmember on the frame to attach it to. So my question then become do I just attach the support to the 1/8 inch steel decking of the cargo space or what are my other options
asked by: Jimmy B
Expert Reply:
The front brackets of the Lippert Components JT's Strong Arm Jack Stabilizer # LC191024 that you referenced actually attach to either of the landing gear legs at the front of the trailer. You would not install them to the frame.
Product Page this Question was Asked From
JT's Strong Arm Jack Stabilizer Kit for 5th Wheel RVs w/ Less Than 58" Between Landing Gear
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- Manual Jack
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Are Safety Chains Required When Using Andersen Ultimate Fifth Wheel Adapter
- Q&A: Product Comparison Of MORryder Scissor Jack Cross Brace And JTs Strong Arm Jack Stabilizer Kit
- Q&A: Recommended Air Bags for a 2025 Chevrolet Silverado 2500 ZR2
- Q&A: Surge Protector for 2026 Thor Pasadena 34XG With 50A Service
- Q&A: JTs Strong Arm Jack Stabilizers for 5th Wheel Over Or Under 58 between landing Gear
- Q&A: Can MORryde X-Factor and Roadmaster Comfort Ride Systems be Installed Together?
- Q&A: Can The Lippert Road Armor Shock Absorbing Equalizer Kit Be Installed With The MORryde X-Factor?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Which Hitches are Made in the USA
- Article: Trailer Wiring Diagrams
- Article: Best Bike Racks for Electric Bikes
- Article: How (and Where) to Connect an RV Propane Grill
- Article: 5th Wheels vs. Travel Trailers
- Article: Converting Your RV Water Heater to Tankless