Can Roof Rack Be Installed with Larger Distance Between Crossbars than What Instructions Advise

Question

Question:

Can I put the racks farther apart than the recommended distance. I would like to put them about 24inch further apart. I have a Scion 2012 xb. Rino rack rs2500 Thanks

asked by: Ken B

1

Helpful Expert Reply:

According to Rhino Rack, the crossbars should be spaced 27-9/16 inches apart, center on center as shown in the provided diagram. Rhino rack chooses the specific mounting points for the crossbars based on where the strongest points of the roof are located. If you were to install the roof rack at a different distance apart, your rack would have an unknown weight capacity which could damage the rack or the vehicle roof if you unintentionally overloaded the rack.

If there was something specific you were wanting to install on the rack, please let me know and I'd be happy to look into it further for you.

expert reply by: Mike L

1

click to enlarge

Tristan M.

6/18/2020

I am looking to get a roofnest roof top tent and I was looking at these 4 roof racks. Can you advise which would be best for my car and the spacing I need to safely have this on top of my car. 2012_Subaru_Legacy . Thank you!

Chris R.

6/22/2020

All of the roof racks available for your Subaru Legacy will pretty much require the same crossbar spacing of around 32". I specifically recommend the Yakima JetStream System that consists of parts #Y99EB because it offers longer bars for a better attachment point for the tent. I just recommend checking with Roof Nest directly about the best fit with this setup as I'm not familiar enough with their products to comfortably make a recommendation.

Tristan M.

6/22/2020

@ChrisR Are my bars I have on my car now ( stock) at the wrong spacing? they are measuring about 27" from center to center of the crossbar.

Chris R.

6/25/2020

@Tristan If they're factory bars I can't imagine they're "wrong", they just differ from where the aftermarket systems have the crossbars set on the roof. Are the factory bars adjustable?

See All (5) Replies to Tristan M. ∨

Answer 1

Yes, you will want to use the 1 and 2 clamps with the bolts in the outer holes on the Rhino-Rack Universal Load Assist #RR-RUSL. Your Thule Wingbar Evo #TH711520 will have a the same shape as the basic Thule Wingbar. The Evo changed the top T-track…

view full answer...

Answer 2

Hi Jeff; that makes sense but the only way to get that information will be for you to measure. When you have a clamp on rack the distances will be listed in instructions or a guide. Racks like the Yakima SkyLine Roof Rack #Y77TB fit on the fixed…

view full answer...

Answer 3

The Yakima SkyBox 12 Rooftop Cargo Box - 12 cu ft - Black Carbonite #Y07334 doesn't have a specific minimum clearance below the crossbars because each fit will be slightly different. My contact at Yakima estimates that the very minimum would be 2…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 8

Hey Jason, whenever available I would recommend going with the channel attachment for roof rack accessories including the Thule Hullavator part #TH898 as its simpler stronger, and it's basically the future of most roof rack accessories as it…

view full answer...

Answer 9

Hello John, thanks for reaching out. Yes, we do have a Thule roof rack that will allow you to install the Hullavator #TH898 on your 2015 Subaru Forester. For that I recommend the following: - Thule WingBar Evo Roof Rack for Raised Rails - Aluminum -…

view full answer...

Answer 10

There is absolutely an option for you! The best roof rack for your 2018 Ford Edge with the Vista glass roof is the Rhino-Rack RS 2500 Roof Rack because it gives your car a rack that is extremely functional while maintaining a clean, refined look. The…

view full answer...

Answer 11

For your 2007 Saab 9-3 with factory rails, I recommend the Evo Raised Rail Feet for Thule Crossbars - Factory Raised Rails - Qty 4 #TH710401 which is compatible with the bars you mentioned, that are often simply referred to as square bars even though…

view full answer...

Answer 12

Hey Donald! For a hitch that fits your 2018 Toyota Highlander I recommend the Curt #C13394. Unlike the other options, this hitch has a concealed cross tube so only the receiver is visible at the rear of your vehicle. That also means you have better…

view full answer...

Can Roof Rack Be Installed with Larger Distance Between Crossbars than What Instructions Advise

Featured Help Information

Miscellaneous Media

Continue Researching