Can E-Track be Installed on a Rubber Floor in a Toy Hauler

Question

Question:

Where is the video showing how to screw the e-track in a toy hauler with a rubber floor?

asked by: Robert H

1

Helpful Expert Reply:

We do not have a video showing installation of E-track on a rubber floor but I have linked some videos that should help. basically you would need hardware that is long enough to go through the rubber floor to the wood or metal subfloor, through that and then into the support beams on the bottom of the trailer.

expert reply by: Michael H

1

Answer 1

You should really attach E-Track directly to the wood floor of the trailer by trimming the rubber covering in the area you want to mount the track. Also I recommend using several E-track backing plates, #e96RR, under the wood floor so that the force…

view full answer...

Answer 2

You'd want to use a backing plate like part #e96RR when installing the e-track like the part #E19148 and there isn't a crossmember you can attach to.

view full answer...

Answer 3

Absolutely, you can mount E track just about anywhere it will fit. We had a customer send in a picture of his E track mounted sided to side on his trailer so the pressure is across all the decking instead of just one board. You can check out the…

view full answer...

Answer 4

I didn't receive your photos, but the manner in which you attach the e-track to your trailer deck will completely depend on what the deck is constructed of and where exactly on the deck you'll be placing the e-track. Without knowing any…

view full answer...

Answer 5

For wall applications, the E-track system #E19148 is mounted horizontally. Make sure you line up the mounting holes with studs as much as possible to give you that additional strength. That plywood is almost too thin to mount to and you will want to…

view full answer...

Answer 6

You would not need to recess the installation of the E-Track Trailer Cargo Control #E19148 to mount it horizontally. If you really wanted to you could, but it definitely wouldn't be required and people install these without it all the time. I…

view full answer...

Answer 7

E-track is not flexible to be bent around a dovetail like you have. You'd have to trim the track at the angle change and attach it in flat sections across the dovetail.

view full answer...

Answer 8

Typically for wood floors we recommend using backing plates like the part #e96RR with the E-tracks like part #E19148 that you mentioned. I attached an install video for an E-track that shows the backing plate being used as well.

view full answer...

Answer 9

E track like the part #E19148 (5 foot section) would work well for what you are looking to do. People use E track for car haulers all the time and it works well. We even have a wheel strap designed for E tracks, part #EM58523 which will work great.

view full answer...

Answer 10

Yes, you can use Erickson Horizontal E-Track item #E19148 as front straps to hold down a car. These tracks have a 2,000 lbs maximum capacity per track. You will want to use the etrailer E-Track Backing Plates w/ Hardware item #e96RR for mounting. The…

view full answer...

Answer 11

The E-track system can install any way you would like on your trailer. It is common to install the E-Tracks so the wheels of a vehicle are on top of the E-track. This allows you to use wheel nets, like part #EM58523, that attach directly to the…

view full answer...

Answer 12

For maximum strength of mounting E-tracks to an aluminum trailer bed you really want to go down to the frame of the trailer. I am sure the aluminum bed of your trailer is pretty strong since it is car hauler but the frame will definitely be the…

view full answer...

Can E-Track be Installed on a Rubber Floor in a Toy Hauler

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching