Hardware Recommendations for Installing E-Track

Updated 05/14/2021 | Published 05/13/2021

Products Featured in This Question

Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1

(1212)

$41.03

etrailer E-Track Backing Plates w/ Hardware - Galvanized Steel - 6" Long x 6" Wide - Qty 4

(279)

$40.19

Question:

I have an open trailer and was wanting to instal the e-track system . I am trying to find what is the best bolts to attach them to my trailer . I have 2 1/2 foot sections . 4 tracks total for each 4wheeler . I am strapping down an 800 pound 4 wheelers . I included a picture of a rough lay out of the tracks . Thanks

asked by: Amy W

Expert Reply:

I didn't receive your photos, but the manner in which you attach the e-track to your trailer deck will completely depend on what the deck is constructed of and where exactly on the deck you'll be placing the e-track. Without knowing any details about that, I can't provide any specifics but I can certainly provide some general advice.

If the decking of the trailer is thicker than 1 inch, I'd use 1/4 x 1 inch lag screws in every 4th hole or so, but I'd highly recommend situating the e-track so that each section of track is also through-bolted to at least 2 cross-members or some other metal structure under the trailer deck.

If the decking of the trailer is thinner than 1 inch, I'd through-bolt the track every foot or so using backer plates like # e66RR, being sure to tie into the trailer cross-members where possible.

expert reply by: Mike L