How To Install The Tekonsha Prodigy RF Brake Controller With A 2015 GMC Canyon

Updated 03/24/2015 | Published 03/22/2015

Products Featured in This Question

(66)

$14.36

Question:

I have purchased from you TEKONSHA Prodigy RF. I have 2015 GMC CANYON wiring ready for in-cab break controller with GM installed hitch. Do I need to splice break pedal switch wire in the harness with blue trailer brake wire for Prodigy to get break signal?

asked by: ANDREW M

Expert Reply:

Since you said you purchased the Tekonsha Prodigy RF Brake Controller, part # TK94FR, you will not need to splice into the wiring on your 2015 Canyon.

You will need to make sure your 7-way connector at the back of your Canyon has an active 12V lead. You will need to plug your trailer 7-way connector into the back of the # TK94FR power module mounted on your trailer. I have attached a photo that shows what each of the pins on a 7-way connector are used for. You can test the connector with a circuit tester like part # PTW2993 to make sure the connector is wired correctly. You will need to plug the 7-way connector from the power module into the vehicle 7-way connector. The remote control simply plugs into a 12V accessory outlet in the cab of your truck.

I have attached a great video you can check out that explains exactly how to install the # TK94FR. It seems the trickiest part of the installation is when you pair the vehicle with the controller. I have also attached the installation instructions you can take a look at.

expert reply by: Jeffrey L