Oil Seals and Wheel Cylinders for a 1999 Jayco Tent Trailer with Atwood Surge Hydraulic Brake System

Question

Question:

I have a 1999 Jayco tent trailer with Atwood surge hydraulic brake system, 10 drum brakes. Do you know what size wheel oil seals I need? I would also like to order the right and left wheel cylinders. I think I see them on your web site, but confirmation would be nice to avoid an error on my part. Also, the correct dust cover. 2? Thanks,

asked by: Arnie

0

Expert Reply:

The wheel cylinders are easy. You will need part numbers BP17-030 left hand and BP17-020 right hand. The seal is a little trickier. You will probably need the 10-19. The inner diameter is 1.719 inches and the outer diameter is 2.565 inches.

expert reply by: Amanda

0

Answer 1

I can't tell you exactly what you're going to have on your trailer, since it's not something that's available in a database, but if you know what type of brakes you've got on your EZ Loader trailer, the axle capacity and the size…

view full answer...

Answer 2

Thank you for the photo of the EZ-Loader boat trailer you are considering. The best ways to determine any given trailer's weight capacity are to provide the VIN to the manufacturer or to check the axles themselves for a sticker or plate that…

view full answer...

Answer 3

If you have Redline brakes (part #40716 is actually Demco), then you will need to use Redline Wheel Cylinder, #BP17-030 (left) and #BP17-020 (right). The correct replacement wheel cylinder for your hydraulic trailer brake assemblies is determined by…

view full answer...

Answer 4

It's possible the left and right side brake assemblies were installed on the opposing/incorrect side they are intended for. While this would not change how the magnets power up it can negatively affect braking. If that's not the case, you may…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Oil Seals and Wheel Cylinders for a 1999 Jayco Tent Trailer with Atwood Surge Hydraulic Brake System

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching