Dimensions of Sealed, Rectangular LED Trailer Clearance and Side Marker Light MCL49AB

Question

Question:

What is the size of the lens? I need 4 lamps with 5 inch by 2 inch dimentions. Can you supply?

asked by: Marcus S

0

Expert Reply:

The dimensions of the Sealed, Rectangular LED Trailer Clearance and Side Marker Light, # MCL49AB, are 3-7/8 inches long, 2 inches wide, and 1 inch deep.

The closest lights we have that fit those dimensions are the Sealed, Miro-Flex, Star LED Marker/Clearance/ID Light, Chrome Cover, 2 Wire, 4 Diode - Amber, # MCL19AB, and the Rectangular LED Trailer Clearance, Side Marker Light, 4 Diode - Amber, # MCL76AB. Neither are exactly 5 inch by 2 inch but they are both very close.

expert reply by: Michael H

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 4

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

We do offer a wide variety of replacement lights for trailer but since trailer manufacturers don't keep a record of what they use on trailers I would need some pictures of the lights you are wanting to replace along with some measurements so I…

view full answer...

Dimensions of Sealed, Rectangular LED Trailer Clearance and Side Marker Light MCL49AB

Products Featured in This Question

Continue Researching