See what our Experts say about this CURT Trailer Hitch

• Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel
  Hey Ron, we have the Curt hitch part # C13103 that is a fit for your 2009 Mercedes R320 diesel. Now do you have any trailer wiring currently? If you have nothing you would need to start with a 4-way which for that we have the # 119250KIT and then convert to a 7-way with the # ETBC7 and then a brake controller like the P3 # 90195 and you'd have everything.
  view full answer...
• Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103
  I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have the diagram that you need.
  view full answer...
• Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103
  You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz. There is some cutting required, but the cut areas are under the vehicle and will not be visible when the hitch is installed. If you have a vehicle with cross bracing member, and in 3 places, if your vehicle does not have the cross-bracing members. The installation instructions, see link below, show exactly where to cut the plastic trunk pan and explain...
  view full answer...
• Trailer Hitch for a 2012 Mercedes R350 BlueTec
  Curt trailer hitch # C13103 is listed as a fit for the 2012 Mercedes R350 BlueTec models. The installation is fairly straightforward so a trusted mechanic or RV dealer that has a service center could perform the hitch installation for you. For wiring, we have the ZCI No-Splice Wiring Harness, # 119250KIT, that will fit your Mercedes. I also recommend etrailer ball mount kit # 989900. It comes with 2 ball mounts; one with a 3/4 inch rise or 2 inch drop and one with a 2-3/4 inch rise...
  view full answer...
• Removal of Fascia on Mercedes 2008 R350 When Installing a Curt Trailer Hitch, Part # C13103
  I spoke with my contact at Curt and he informed me that the underbody panel needs to be removed before installing the Curt Trailer Hitch Receiver, part # C13103, on your 2008 Mercedes R350. He said that although there are only 4 bolts holding the fascia, the underbody panel is held in place by 7 plastic pins, or bolts, so caution needs to be used when removing these. I have attached the installation instructions for the C13103 hitch.
  view full answer...
• Availability of Hitch for 2006 Mercedes R500
  We offer two different Class III hitches that are a fit for your 2006 M/B R500. Both the Curt # C13103 and the Draw-Tite # 75470 offer a 3500 lb towing/ 350 lb tongue weight capacity, but the warranty requirements of the Curt hitch stipulate that a stabilizing strap like # 18050 needs to be used for non-trailer loads like bike racks or cargo carriers. Because the Draw-Tite hitch has no such stipulation, I would recommend the Draw-Tite over the Curt hitch. I have linked you to the installation...
  view full answer...
• Trailer Hitch and Wiring Recommendation for a 2006 Mercedes R350
  For a hitch for your 2006 Mercedes Benz R350 we do have the part # C13103 as a fit like you have determined. Now for wiring we have universal wiring kits like the part # C56236 which are a confirmed fit. Or, if you wanted a wiring harness that does not cut into the wiring of your vehicle at all we have the ZCI part # 119250KIT which would also work well. If you wanted to do some towing you might be interested in etrailer ball mount kit # 989900. It comes with 2 ball mounts; one with a...
  view full answer...
• Ground Clearance of Curt Hitch Installed on 2008 Mercedes Benz R320 CDI
  For your 2008 Mercedes Benz R320 CDI we have the Curt hitch part # C13103 as a confirmed fit. This will fit your vehicle will and will not sit too low at all. When we installed this hitch on a similar 2006 MB we found that from the top of the hitch opening down to the ground measured 10-1/2 inches.
  view full answer...
• Wiring Kit Compatible with 2011 Mercedes-Benz R-Class
  The answer you referenced is from early 2015 and will be updated because we have since learned the Tekonsha ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit # 119250KIT is a fit for your 2011 R-Class Mercedes-Benz. The zero contact interface uses sensors to capture the signal on your wires so they are uninterrupted and yet the powered modulite can transfer the signal to your trailer wiring functions. It is a great option for you if you...
  view full answer...
• Hitch Fit for 2006 Mercedes-Benz ML500
  Unfortunately, the hitches we offer for a 2006 Mercedes-Benz ML500 aren't compatible with vehicles that have the air-ride suspension option. I wish we had better news for you. If you were needing the hitch to provide a mounting point for a bike rack, you could use a hatch mounted bike rack like the Thule Gateway 2-bike model, part # TH88VR or the 3-bike model, part # TH78VR which would be a good alternative to a hitch mounted bike rack.. I've linked to a product demonstration video featuring...
  view full answer...
• Torque Specifications to Install the Curt Hitch Receiver C13103 on a 2009 Mercedes-Benz R-Class
  The M10 x 1.50 CL 10.9 fasteners will need to be torqued down to 45 lbs-ft and the 7/16" 59 lb-ft for the Curt Trailer Hitch Receiver # C13103. This is in line 8 of the instructions, we usually do not answer that question because companies like Curt often update and improve their torque specs, so always check the attached current specifications for the most recent recommendations in case they have been updated. This is a confirmed fit for your 2009 Mercedes-Benz R-Class. I have attached...
  view full answer...
• Trailer Hitch For A 2009 Mercedes-Benz R350
  We do have a trailer hitch option for your 2009 Mercedes-Benz R350, but the # C13190 that you mentioned is not going to fit your vehicle. The correct hitch for the 2009 Mercedes-Benz R350 is the Curt class 3 hitch # C13103. This is a 2" receiver rated for towing 3,500 lbs and 350 lbs of tongue weight.
  view full answer...
• Trailer Hitch Recommendation for a 2012 Mercedes Benz R350
  The Curt Hitch part # C13103 that you referenced has been confirmed as a fit for your 2012 Mercedes Benz R350 so it would work well for you.
  view full answer...
• Will the Curt Trailer Hitch # C13103 Fit on a 2010 Mercede-Benz R350 BlueTec Diesel
  I have checked with my contacts at Curt and the # C13103 is confirmed as a fit for your Mercedez-Benz R350 with Blue Tec Diesel option. This is a Class III trailer hitch that offers a 2-inch receiver opening and is rated for towing up to 3,500 pounds and a maximum tongue weight of 350 pounds. You may also consider the ZCI Circuit Protected Vehicle Wiring Harness # 119250KIT that will not require you to cut or splice into your vehicle's wiring system. This will supply a traditional 4-way...
  view full answer...

Do you have a question about this Trailer Hitch?