2013 Chevrolet Spark Replacement Mirrors

Hey John, what dimensions specifically of the Curt A20 fifth wheel hitch part #C54VJ are you looking for? The height range of the hitch is between 17-1/2 and 21-1/2 inches which is normally the dimension people are looking for.

Hey John, thanks for reaching out! The correct Curt A16 5th wheel hitch fitment for your 2010 Toyota Tundra is the Kit #C57VJ, and that's if you have the 6-1/2' bed. This comes with a custom bracket mounting kit so you'll have minimal…

Hey Paul, yes the Air Lift LoadLifter 7500 XL part #AL57595 is a confirmed fit for your 2014 Ram 3500 4WD with a single rear wheel axle. Are you wanting a compressor kit as well?

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Chuck! For a 1999 Ford F-250 we only have the driver's side item #CM47597. I do have an alternate set though. It is the K-Source Custom Extendable Towing Mirrors item #KS61069-70F. These are custom fit for the 1999 Ford F-250 and have the…

Hello Nicholas, Yes, the #F2398 will be the right fit for your 2006 Ford F-250 Super Duty RWD Diesel, because your truck is RWD it makes it a 2 wheel drive model. So any of the "used" items on that page will work for you. The returned items…

Hello Alan. The brake control harness on a 2012 Jeep Liberty with the factory tow package should be on the drivers side under the dash. If you are sitting in the drivers seat it will be kind of near where your left leg/knee would be. You will…

Hey Edward, thanks for reaching out! I recommend using the Curt Rebellion XD Shock Absorbing Adjustable Ball Mount #C83WR as-is because adding the RockerBall will just add more potential for uncontrolled movement as they might work against each…

Hey Ben, thanks for reaching out! You'll want to go with the Redarc Tow-Pro Liberty Kit #RED82CR because it comes with the controller, the pigtail adapter for your 2006 Tundra, and different cutout panels that make the controller look like more…

The Curt Rebellion XD part #C57UR measures 10 inches from the bottom of the shank that inserts into the hitch opening to the bottom of the ball mount. So you would lose 10 inches of ground clearance measured from bottom of your hitch.

The distance from the hitch pin hole to the center of the hitch ball of the Curt Rebellion XD Shock Absorbing Adjustable Ball Mount #C57UR that you referenced is 13-1/4 inches.

Hey Jack, the Furrion Chill HE RV unit like the part #FR52PR is going to be your best solution. It is the quietest and draws the lowest amount of power at 11.2 amps compared to most similar options that are around 15. We've tested all of the…