2006 RV Jack Pads

For 10" octagon shaped jack feet you would need the SnapPad EQ Octagon Jack Pads #SN76FR that you were already looking at, but before purchasing you'll need to measure just how tall the edges stick up from the ground since your jack feet…

Since the Lippert Hydrauluic Landing Gear Feet are 12 inch in diameter and round the correct Snappads would be the part #SP74FR4.

Hello Tom, Congrats on the new 2025 heartland corterra 3.0 5th wheel, what is your favorite feature? I cannot find the exact weight anywhere for the Stackers StayPut Jack Pads and Leveling Blocks #VAL93MB. I do know that they will be able to handle…

Hey Phil, so since we know you have 10 inch octagon jack feet on your 2025 Jayco Alante 29s the SnapPad EQ part #SN76FR is for sure the correct fit. The Stromberg version is called the Base Pad Shoe and it looks like a horse shoe to me almost. I…

Hey Frank, We would need to know the diameter and shape of the footplate for your tongue jack in order to find the correct SnapPad to fit it.

Personally I prefer the SnapPad XTRA Jack Pads #SP54FR4 over the Stromberg Carlson #SC99MR as they have been around much longer and proven themselves to be a quality product. Both these will fit 4 jacks with a 9" round landing pad.

The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz Tube…

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

Hey Jody, your 1/0 wire that you have for a winch wiring kit would work just fine with the Redarc Alpha 50 amp part #RED78NR. Having heavier gauge than needed would just mean you'd have max amperage available for the charger at all times.

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

No, it's not but I have alternative that does or a adapter if you already own the etrailer SD Non-Binding Tow Bar item #e47ZR. If you already own the etrailer SD Non-Binding Tow Bar item #e47ZR you can use the etrailer Tow Bar Adapter Brackets to…

Hi Bernadette, You would want to plug your 50 amp to 30 amp adapter in to the power pedestal and then connect your Portable Power Watchdog Surge Protector #HU42VR to the adapter. Once the Watchdog lights show that the connection is good you can…