2000 Jeep Wrangler Grille

Hello Francis, thanks for reaching out. That is a pretty tall order. The strongest hitch extensions we offer are the TorkLift SuperTruss Hitch Extensions like part #TLE1548 (10,000 lbs towing 500 lbs tongue weight). These can only be used with a…

Hey Rich! I checked with Westin and their MAX Winch Mounting Tray item #W62PF adds right at 15-1/2" to the front of your 2025 Nissan Frontier. I recommend adding a couple of the Westin MAX Winch Tray Tow Hook item #46-3005 to have a couple extra…

I can say that Curt doesn't consider the hitch a fit, but if you look at the provided photo, you can see the mounting hole spacing on the hitch and compare it to the frame member of your truck.

Good question, Chuck! You will not need the Brake Relay #RM-88400 when installing the Roadmaster 4 Diode Wiring Harness #RM-15267 on your 2018 Jeep Wrangler JL Unlimited. This is because the stop light switch circuit on your Jeep JL will go dead…

The closest thing that we have to what you are looking for is something like the Demco #Demco Trailer Coupler w/ 5-Position Adjustable Channel #DM6125-81 (which can come in a variety of options) which you can interchange with the Demco Lunette Ring…

Hey Will! You can flat tow your 2014 Jeep Wrangler Willys with a Dana 44 axle as long as you have a two-speed transfer case. Make sure to check your owner's manual to verify this information. Does it have the standard bumper on the front?…

Using the hitch extension will reduce the tongue weight capacity of the trailer by 50 percent. But if you have a 2 1/2 inch trailer hitch receiver and use the Titan hitch extension #RP45292 the tongue weight capacity will not be reduced. At the 24…

Hey Zach. What suspension components are you needing? There's no database that will allow me to look up part numbers for what's on your 2010 Keystone Raptor so you'll need to find some part numbers off of yours or take some measurements.…

Hey Martin! Carrier is no longer making RV AC units. Although there were some plug and play replacements available in the past, everything has switched to the new R32 refrigerant following 2025 EPA guidelines. This means a complete system replacement…

Hey David, thanks for reaching out! The shank on the Curt Adjustable 2-Ball Channel Mount #C45926 isn't available by itself, unfortunately. What were you planning on using it for? I might be able to find an alternative solution for you!

I spoke with the manufacturer, MORryde, about the dimensions of the MORryde Refrigerator Tray #MR59RR and their tech stated the distance from the ground to the bottom of the tray is 1.61". I can't exactly tell from your photos what your lip…

For the Thule Hullavator part #TH898 the hardware that goes through the part #TH57BH is #853-5439, #TH93BW and #951061254.