Vehicle Style: 1500 - Crew Cab - 5-1/2 Foot Bed - 5.7L V8 Engine - HEMI Change
Exhaust Systems Specs:
MagnaFlow Exhaust Systems Features:
...span>Dual exhaust system Split rear exit position The cat-back system is the portion of the exhaust system from the outlet of the catalytic converter to the tailpipe. MagnaFlow systems have Mandrel bent tubes...
Tech Tip:
For vehicles with 5.7L V8 engine, exhaust is intended for models that do not have a factory dual exhaust.
More Information >Exhaust Systems Specs:
MagnaFlow Exhaust Systems Features:
...span>Dual exhaust system Split rear exit position The cat-back system is the portion of the exhaust system from the outlet of the catalytic converter to the tailpipe. MagnaFlow systems have Mandrel bent tubes...
Tech Tip:
Exhaust is intended for models with a factory dual exhaust.
More Information >Exhaust Systems Specs:
MagnaFlow Exhaust Systems Features:
...the dual outlets A layer of stainless steel wool insulates the perforated core to absorb noise, regulate high exhaust temperatures and prevent blowouts No baffles, chambers or louvers that restrict airflow...
More Information >Videos
for Exhaust Systems
Help Articles
for Exhaust Systems
Expert Answers
for Exhaust Systems
When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or…
view full answer...According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement…
view full answer...If you check out the picture I attached you can see that the roller and slide out awning assembly of the Solera RV Slide-Out Awning #LCV000435661 actually will sit below the awning rail so your setup having a tight clearance between the rail and…
view full answer...Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in…
view full answer...Please note the attached instructions. The Lippert Anti-Billowing Kit for Solera Slide Topper Awnings, #LC78FR should be installed on the end of the awning that is closest to the front of the unit. 1. Make sure awning is fully retracted. 2. Place…
view full answer...You sure can! You'll just need to know the brand and model of your slide out awning. For example the Solera Slide out awning #LCV000168109 uses replacement fabric #LCV000442075. We only sell fabric for Solera awnings at this…
view full answer...Hi Chris; your 2022 Ford Expedition will have a Normally Closed application, and it is possible when installing the Roadmaster Brake-Lite Relay Kit #RM-88400 that you'll need Hy-Power Diode #RM-790. I can't say…
view full answer...The best way you can determine if your 2021 Ford F-150 has LED or Incandescent lights is to call the dealer with your VIN number and they should be able to tell you. If your vehicle has LED lights, you can use the Roadmaster Universal Wiring Kit…
view full answer...For vehicles where it's nearly impossible to find a dedicated stop light circuit the Roadmaster Universal Stop Light Switch Kit #RM-751000 is a great solution. Basically it gets power from your battery and has…
view full answer...Ultimately you do not need a converter as you can wire the tail lights on your 2022 Ford F-150 to operate as brake and turn signals just like the lights on your motorhome. You will need to use the Roadmaster Universal Wiring Kit with Smart Diodes…
view full answer...I checked the owner's manual for your 2021 GMC Yukon XL, and yes, it is perfectly fine to flat tow. That being said, you are going to need these components: - A base plate - Tow bars - Braking system - Tow bar wiring - High-Low…
view full answer...I advise measuring the two spindles that you have and making sure that the parts that you are wanting to interchange will be a compatible fit. I have included a photo that shows where where to take these measurements on your exiting spindles. These…
view full answer...Filter Products (6)
Contact and Help
What our customers are saying:
WOW! I am impressed! I called to place my order and real person answered, spoke perfect English, albeit a slight southern accent, and my order was sent within a day, shipped quickly and I had it a few days later. I saved over a hundred dollars over local and installed it my self. I cant imagine how that they could do any better. THANKS!
Eric
Cedar Springs, MI