I attached a diagram that shows how most 7-way rounds like the #PK11720 that you referenced will get wired up. As long as you got yours wired up correctly and your trailer taillights and brakes are functioning correctly that's all that should…
The 18" x 18" x 1" Buyers Products Polymer Outrigger Pad #337OP18X18P does not have a weight rating. These are designed to provide a greater surface area for your trailer jack feet to rest on for better stability so a weight rating…
For your bolt pattern of 4 on 4 inch the largest wheel and tire size we have is 175/80D13 like the part #AM3S030 which has an overall diameter of 24 inches. This will be right at 6 inches taller than your current tires.
Sounds like you have a rear ramp/door on a horse trailer and need a cam style latch to hold it in place when shut. For that the 36" Lock Side-Door Bar Lock Assembly #305736 can be used for this. It would be just a matter of mounting the assembly…
For a pedestal mount LED light that would work great on your trailer to light up the ramp I would recommend the Opti-Brite LED Work Light part #TLL50FB. I attached an install video for you to check that shows the light being used in a very similar…
I went and pulled these from the warehouse. From the included diagram you can see the width of the #PK-28B tapers from top to bottom. Included is the video review for additional information as well.
It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
The Air Lift 1000 Air Helper Springs for Coil Springs part #AL60769 which are a fit for a 2013 Chevrolet Suburban do not require the coil springs to be removed for installation. I will admit though, there are times were I thought it would be faster…
Trailer tires typically don't wear out before they need to be replaced due to age. In nearly every situation a tire will need replacing when it hits 6 years of age unless you have a suspension issue that causes a wear issue.
Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…
Yes, you can absolutely drill holes in your trailer tongue to install the 10,000 lb capacity Buyers Products Straight Tongue Trailer Coupler #3370091560. This is a pretty common occurrence due to the various bolt hole patterns of straight tongue…
Filters
