Built for Lippert Through-Frame Slide-Out Systems, a motor replacement keeps your room moving smoothly. Match your setup by confirming 12V, the correct gear ratio like 18:1, and RPM such as 9,000, especially if your slide uses two motors. You can replace the motor with the slide extended, and some applications use an integrated motor/gearbox, so check which style you have.
Installation is typically a direct bolt-in. If a mounting hole looks unthreaded, that's normal—the bolt passes through the motor and threads into the actuator tube. Support the slide as needed, align the drive, and tighten hardware evenly to reduce binding or noise after install.
Yes, the slide can be out during motor replacement. To verify the motor is the issue, use a multimeter and swap polarity to see if it runs. If it runs, trace wiring for faults; if it doesn't, replace the motor assembly and match specs like 18:1 if your slide uses 2 motors.
Yes, the motor and gearbox are supplied together, not separately. Plan to replace the assembly as a whole. If you were only hoping to swap internal gears, check your current unit's condition and labeling, then select the combined motor/gearbox to match those specs.
Match the RPM printed on your existing motor. Some slides use a high-speed 9,000 RPM motor, while others use a lower RPM under load. If your system uses 2 motors, confirm both have the same RPM and 18:1 gear ratio so they stay in sync.
Match the specs on your current motor. Check the label for 12V, amp rating, RPM (like 9,000 RPM), gear ratio (like 18:1), and rotation direction. Verify it's for a through-frame slide, not a Schwintek or hydraulic setup. If your slide uses 2 motors, confirm both share the same gear ratio before replacing.
Hydraulic Parts
Motor Parts
Filters
