Hi Mark, You shouldn't need to use the Furrion 7-Way Vehicle Power Adapter part #FR87PR because your 2018 Ram 2500 is from the fourth generation of the Ram 2500 before they did the huge overhaul that changed the circuits and resulted in the newer…
Hey Arkadius, welcome back! Yes, the ducted version of the Chill Cube comes with a remote. However, you're going to need the complete system for a replacement. You can choose from the following based on color: -Furrion Chill Cube RV Air…
Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…
Hey Jerry, does the LED still light up on the front of the Mighty Cord SurgeMinder Surge Protector and Circuit Tester #SU39SR? If it was actually overloaded it would have damaged the internals of it and it wouldn't work as a surge protector any…
Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…
Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…
Hey Kenny, welcome back! The reason for that note is because all of the new systems since 2025 use R32 refrigerant due to EPA regulations. Any 2024 and older systems use R410A and their parts are not compatible with the R32 units. It doesn't mean…
Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…
Hey Scott. The Furrion Variable Speed Chill Cube RV Air Conditioner w/ Heat Pump like item #FR97TQ in black or item #FR67TQ in white are only available in 18K btu capacities. The Chill Cube uses variable-speed technology, which allows it to reduce…
Hey Ken, welcome back! The Chill Cube #FR24TQ is just the rooftop unit. The #FR67TQ is the rooftop unit with the air distribution box (ADB) and the remote. This is everything you need for a complete installation. The #FR59TQ is the AC unit with the…
Hey Steve, yes the Dexter Nev-R-Adjust Brake Assembly set part #23-458-459 is the correct set for your Airstream based on the part numbers you mentioned. Also the hub/drum part #8-388-80UC3 that you referenced as well would be correct for your…
Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…
In these days of customer "no service" I am usually disapointed when doing business with people I don't know. It was refreshing doing business with you. I'm impressed!
Randy
Watkinsville, GA
RV Interior Lights for vanity with incandescent
Brighten your sink area with a vanity light that suits tight RV spaces. These incandescent light fixtures work on typical 12V setups and accept 912 or 921 bulbs, so you can tune brightness or switch to LED later. Check dimensions and mounting needs; some fixtures don't include bulbs or hardware, and wire polarity may not be marked.
Yes, you can swap the incandescent bulbs for LED in most RV vanity lights. Match the same 12V wedge-base bulb type your fixture uses. LEDs can give just as bright light with a fraction of the amperage. Pick a brightness and color temperature that suits your space.
Not all do. Some fixtures do not come with bulbs or screws, and instructions may be minimal. Reuse hardware if it matches, or source fasteners that fit your mounting surface. If bulbs are included they're typically incandescent, and you can replace them with LED if desired.
Confirm your RV uses 12V power at the mount. Measure the available length; options are often around 18" or shorter two-shade styles. Check for a wall switch or a switch on the fixture; you may need to add a toggle if none exists. Verify wire polarity since some wires aren't clearly marked. Use basic tools and secure it to a solid surface.
Both 912 and 921 fit if your incandescent vanity light uses a T-5 wedge base. They are interchangeable in that base. The 921 draws more power and burns brighter than the 912. For LEDs, choose a 912/921 wedge-base style with the lumen and color you want.
It can, if it fits and is 12V. Measure carefully for small or recessed areas to ensure the base and shades clear nearby walls. A solidly built fixture can hold up well when bounced around in a trailer or boat. Use LED bulbs if you want to reduce battery drain.
Filters
