Good question, Dave. The easiest way is to match the RVpaws kit to your jack leg or leveling system. For example, there are specific kits for the brands and lineups out there: Standard 2" round jack leg = #RV57FR Standard 2" square jack leg…
Hey Arkadius, welcome back! Yes, the ducted version of the Chill Cube comes with a remote. However, you're going to need the complete system for a replacement. You can choose from the following based on color: -Furrion Chill Cube RV Air…
Good question, Mark. The RVpaws V2 pads are definitely stronger than most OEM setups. They are built from 1/4" plate steel with 6 gussets, so they’re a nice upgrade over thinner factory-style feet that have about 1/8" thick plate. The right…
Hey Dennis! If your fifth wheel uses standard 2" square leveling jack legs, the RVpaws articulating jack pads #RV24FR is the correct kit. If the legs are standard 2" round instead, you’d use #RV57FR. If you actually have Lippert Titan or…
Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…
Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…
Hey Jerry, does the LED still light up on the front of the Mighty Cord SurgeMinder Surge Protector and Circuit Tester #SU39SR? If it was actually overloaded it would have damaged the internals of it and it wouldn't work as a surge protector any…
Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…
Hi Jeff! To be perfectly honest, there is no difference between them. The Redarc Tow-Pro Liberty Brake Controller w/ Custom Harness #RED72CR comes to us already put together to fit your 2017 Toyota Tacoma, whereas the Redarc Tow-Pro Liberty Brake…
Hey Scott. The Furrion Variable Speed Chill Cube RV Air Conditioner w/ Heat Pump like item #FR97TQ in black or item #FR67TQ in white are only available in 18K btu capacities. The Chill Cube uses variable-speed technology, which allows it to reduce…
Hey Ken, welcome back! The Chill Cube #FR24TQ is just the rooftop unit. The #FR67TQ is the rooftop unit with the air distribution box (ADB) and the remote. This is everything you need for a complete installation. The #FR59TQ is the AC unit with the…
Hey Kenny, welcome back! The reason for that note is because all of the new systems since 2025 use R32 refrigerant due to EPA regulations. Any 2024 and older systems use R410A and their parts are not compatible with the R32 units. It doesn't mean…
In these days of customer "no service" I am usually disapointed when doing business with people I don't know. It was refreshing doing business with you. I'm impressed!
Randy
Watkinsville, GA
RV Interior Lights — Puck Light with On/Off Switch
Pick targeted lighting in your RV with puck light fixtures that include an on/off switch. They let you control individual spots; options with a hard button can sidestep the sticky rubber switches used on some factory lights. For a clean swap, confirm the light's diameter and mounting hole pattern so the new unit lines up with your existing cutout.
Wiring is typically a simple two-wire connection and then fastening with screws. Before mounting, test the On/Off Switch and make sure the lens cover twists on and tightens fully. If the cover won't seat, check the notch or slot alignment on the base and lens to ensure they engage cleanly. Most have plastic lenses that mimic glass and are less prone to shattering.
Measure the bezel diameter and the mounting hole spacing on your current light. Puck Lights can be slightly different in diameter, and mounting holes may not line up perfectly. If it's a little smaller, it can still blend in once installed. Plan for minor adjustments or reuse of an existing flush-mount holder if needed.
Choose warm white if you want it to blend with typical RV interior lighting. Some warm white Puck Lights are listed at 3,500 kelvin. Compare the light color in your RV and pick the same description. If you're replacing just one, turn on nearby lights and check that the new Puck Light with On/Off Switch looks the same before finalizing install.
A hard push button in the center is a solid pick for reliability and feel. Rubber-covered or slide switches can stick or fail, which is why many swap to a push button style. If you want to control lights individually instead of all at once, choose Puck Lights with their own On/Off Switch at each fixture.
Filters
