...You can use the RV Propane Gas Detector # RS64FR (white) or # RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current...
The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…
Since the Atwood 31013 LP Detector has been discontinued you can replace it with the RV Propane Gas Detector - 12 Volt - 2 Wire - Black #RS44FR. This detector is a surface mount design and can easily swap out your old unit in just a few minutes.
Harvey, you’re right on target asking about sizing. The AFMD35121 was a 35k BTU unit that’s been discontinued. You can step into the 35K BTU #DMC74MR furnace by Dometic, but it is 2 inches taller than your current one. Most folks just enlarge the…
...looking to replace an OLD propane detector in a pop up, This is the part I have that is old and not working see pictures
looking at your Atwood 36720 RV Propane Gas Detector - 12V DC, White...
...We do have a couple of options to replace your Atwood 36636, and you can use either, with the only difference being the color:
- RV Propane Gas and Carbon Monoxide Detector - Black # RS54FR or White...
Hey Jeff, thanks for reaching out! Yes, if you buy the RV Propane Gas and Carbon Monoxide Detector #RS54FR right now in 2025 and install it, it will last until 2030. Did your last detector go out, or are you just looking to get your RV ready for…
Hello Dennis, You can use your current Chinese races, and just get the bearings from the Timken Bearing Kit, 14125A/25580 Bearings, 14276/25520 Races, GS-2125DL Seal #TMK32VR. You will want: - Inner bearing: Timken Replacement Trailer Wheel Bearing -…
Filters
