Hi Jordan! The Dexter Bearing Kit for 1-1/16" to 1-3/8" Tapered Spindle #DX76ER uses bearings and seals that are made overseas. They aren't really "branded", per se, but Dexter does have them made specifically for them. If you…
Hey Alex. From the information I can find online it does look like your 2011 Keystone Cougar 318SAB does come prepped for a second AC unit. The bedroom roof vent should be reinforced and pre-wired for a 13.5k or 15k BTU unit. To check if your trailer…
Hey Michael! Since you were looking at the SoftStartRV Soft Start #SSR54FR are you wanting that built in as well? The Active Controls ActiveStart Plug-In Soft Start for RVs #AS94FR is a soft start and surge protector all in one. If you aren't…
Hey Dan, I attached a picture that has all of the dimensions of a similar shank that comes with the Andersen Weight Distribution System part #AN28VR that you referenced. Let me know if you will have enough clearance, are you running your current…
Hey Scott, the backspacing for the wheel of the Kenda Tire and Wheel part #KE46JV that you referenced is 3 inches. This is based on fact the wheel is 5 inches wide but then you have to add in an inch for the flange lip and then just divide by two.…
Hey Leonard! Yes, you can use the hitch pin hole furthest away from the head to install the Andersen Weight Distribution Hitch #AN53VR in your receiver. Both of the hitch pin holes can be used to secure the shank. What kind of trailer are you…
Hey David, the Replacement Locking Lever Latch part #TH85ME that you referenced does fit your older model RodVault from before it was a Thule brand rack. It's only option to get replacement keys unfortunately which I know is super frustating.
Hey Ray, thanks for reaching out. If you are set on placing the propane tank inside the toolbox, it can be done safely as long as the box is properly vented at the bottom. Propane is heavier than air, so if there is ever a small leak it will settle…
Hey Gus! Yes, the Trailer Coupler for Yakima Rack and Roll Trailers - 2" Ball - Bolt On #Y08123 will fit your older Rack and Roll trailer 8008106. It is the same coupler for the old model and the current #Y08107. This does not come with hardware…
Yes, it will Jim. The Andersen Weight Distribution Hitch w Sway Control item #AN28VR includes a shank with a 6" rise. This will put the top of the hitch ball 6" above the top of your receiver, which will be perfect for your trailers coupler…
Hey Keegan, welcome back! We've got quite a few options to swap your pin box over to a gooseneck connection like the Gen-Y item #GY48GR you were looking at. What I'll need to determine the correct one is the information on the sticker…
Hello Patrick, thanks for reaching out. The pole tongue adapters are brand and model specific to the weight distribution hitch. Sadly, Andersen does not make a pole tongue adapter, so there is not an option for using their WD hitch on a straight…
Filters
