Videos
for Battery Charger
Help Articles
for Battery Charger
Expert Answers
for Battery Charger
Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch…
view full answer...If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
view full answer...On a single axle trailer you will want to have a hanger spacing of around 22-3/4 inches when using the 23-1/8 inch long Double-Eye Spring #e59SR. This will allow that rear shackle to correctly lean away from the axle for proper suspension travel.
view full answer...On single axle trailers typically you put the hanger spacing right at 1/4 of an inch shorter than the leaf spring length from eye to eye center. So if you were using the leaf spring part #e54SR that you referenced which measures 25-1/8 inches long…
view full answer...Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand…
view full answer...The Repair Kit Fulton Wedge-Latch Cast Head Coupler, #F670801, is designed to fit the coupler #BD44125W0317 which does take a 2-5/16 inch ball.
view full answer...The Furrion Single Zone Controller part #FACC12SA-BL does have a dip switch setup underneath the cover of it.
view full answer...The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead…
view full answer...90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.
view full answer...The Dometic 310 Part-Timer RV Toilet, #DOM37FR that you currently have, in tan, is a standard-height RV toilet with a ceramic bowl and slow-close lid. It is 20" tall with a seat length of 15-1/4" and seat cutout dimensions of…
view full answer...You'll just need to run to your local hardware store and grab a supply line to connect your Dometic 310 Part-Timer RV Toilet #DOM37FR to your water inlet. I had to do the same in the attached video below when the new toilet I was installing…
view full answer...The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for…
view full answer...