Under Seat Storage Specs:
Features:
Got stuff rolling around on the floor of your truck? Corral it with a custom cargo organizer. The tough polyethylene plastic bin stores valuables under your vehicle's rear cab seats, hiding them from thieves. Converts easily to a gun case.
Installation Notes:
Metal factory trays under the seat will need to be removed for installation. These can be interchanged if needed
Designed for vehicles without factory navigation system
Does not fit models with factory subwoofer
More Information >Videos
for Car Organizer
Help Articles
for Car Organizer
Expert Answers
for Car Organizer
The stop light switch that you will need to connect the red wire to on the Brake Control Plug-In Harness for Tekonsha part #20127 may be pre ran to a set of wires taped to the underside of the drivers side vehicle dash. If the wires are not present…
view full answer...What you are wanting to do is very possible with the GO Power Solar Panel kit part #34273836. You could mount it on your pin box and then run the wiring to your batteries via an SAE connector. We…
view full answer...I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I…
view full answer...I can help you finish up the installation of your brake controller on your 2015 Jeep Cherokee Limited. I really like the Tekonsha P3 #90195. This brake controller is a proportional controller, which means whatever pressure you press the tow…
view full answer...Yes, the best option we can offer you to add fuel capacity is with the DeeZee Truck Bed Auxiliary Tank part #DZ91752X which should fit in the space you have between the cab and 5th wheel hitch no problem as it is only…
view full answer...If you need 18 feet of E-track I recommend using 2 pieces of 8 feet Horizontal E-track part #E19135 and 1 piece of 2 feet E-Track part #EM59150. 8 feet is the longest Horizontal E-Track available. The E-track pieces are not designed to be mounted…
view full answer...Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR.…
view full answer...To determine which brake assemblies would be needed, you will need to measure your existing brake drums as shown in the provided photo. Since your trailer has a 14,000 lb capacity, you most likely have tandem 7,000 lb axles, which typically use a…
view full answer...The caliper bracket you are looking for is the Replacement Mounting Bracket #KCMB12D which is compatible with the 5 bolt mounting flange you have as well as the 225 Kodiak Dacromet calipers you have as well. Then for a bolt kit…
view full answer...As far as height adjustability and weight capacities the Curt Q20 #C16130 and the Curt A20 #C16140 are identical. They both have a Gross Towing Weight of 20,000 lbs, a Vertical Load Limit of 5,000 lbs, and a height range of 13-17 inches. When it…
view full answer...Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...